Actiontec electronic 56K V.90 manual Kn

Result Codes:

OK	n = 0
ERROR	Otherwise

\J Adjust Bits/s Rate Control

When this feature is enabled, the modem emulates the behavior of modems that force the DTE interface to the line speed.

Command	Effect
\J0	Turn off feature (default).
\J1	Turn on feature.

Result Codes:

	OK	n = 0, 1
	ERROR	Otherwise
\Kn		Break Control

Controls the response of the modem to a break received from the DTE or the remote modem or the \B command. The response is different in three separate states. The first state is where the modem receives a break from the DTE when the modem is operating in data transfer mode:

Command	Effect
\K0	Enter on-line command mode, no break sent to the
	remote modem.
\K1	Clear data buffers and send break to remote modem.
\K2	Same as 0.
\K3	Send break to remote modem immediately.
\K4	Same as 0.
\K5	Send break to remote modem in sequence with
	transmitted data. (Default.)

58