Actiontec electronic 56K V.90 manual

Page 40

At the Advanced settings window, type the following in the Containing text field: V.90 PCI Windows Modem. Click Find Now.

When a file is found, it will have the name oem#.inf. To delete a file, highlight the file name by clicking once and then choose Delete from the File menu.

Next, go to the Advanced tab and type the following in the Containing text field: V.90_PCI_Windows_Modem as shown below.

After Windows finds the other file, delete it as before. Restart your system and follow the installation procedures outlined in the “Installing the Modem.”

39

Image 40

Contents 56K V.90 PCI Voice/Fax Windows Modem Table of Contents Introduction For Windows 95 and Windows 98 Installations Do This FirstFor Windows NT 4.0 Installation For Windows 2000 Professional Installation Installing The Modem Hardware InstallationInstalling The Modem Connecting Devices to the Modem Connecting DevicesConfiguring Windows Page Configuring Windows 95B Page Configuring Windows Page Next Page Page Configuring Windows NT Page Page Page Configuring Windows 2000 Professional Page Page Page Page Confirming the Installation of the Driver in Windows Page Installing Communications Software Modem’s Voice FeaturesPage Troubleshooting Windows 95/95B/98More Info Panel Does Not Install Windows NT Common Problems No Dialtone ErrorCan’t Connect at 56K Uninstalling the Modem Uninstalling in Windows 95Ltcom.vxd ltwave.inf Page AT Commands Repeat Last CommandAnswer Command ATXnCarrier Control Echo Command DnDialOnline Data Character Echo Command Hook ControlMonitor Speaker Volume Request ID InformationThis command turns the speaker on or off Modulation HandshakeSelect Pulse Dialing Return On-line to Data ModeResult Code Control DCE Response Format Result Code OptionExtended Result Codes Dial Tone DetectLong Space Disconnect Busy Tone DetectRecall Stored Profile Auto Retrain Data Carrier Detect DCD ControlDTR Control Load Factory Settings22bis Guard Tone Control Auxiliary Relay option Asynchronous Communications ModeLocal Flow Control Selection This Command is effective only for use in Japan View Active Configuration and Stored Profile Data Set Ready DSR OptionLSD Zn=x Store Telephone Number \Bn \AnModem Port Flow Control \Kn Same as 4.Default \Nn \Tn Inactivity Timer \Vn Protocol Result Code\Xn XON/XOFF Pass Through Data Calling ToneV90=x Downstream Rate and Control Enable/Disable Data Compression AT Commands for Testing and DebuggingWrite to/Read from DSP Register Line-to-Line LoopbackATI11 XXX Registers Reference TypeAscii Connection Completion Time-Out Comma Dial Modifier TimeS10 S11 Dtmf Dialing SpeedS21 S14 General Bit Mapped Options StatusS22 S24 Timer to Control Sleep Mode S28 Modulation Enable/DisableS30 Inactivity Timer S32S35 Data Calling Tone S37 Dial Line Rate defaultS36 S42 Auto Rate default 1, range S38 56K Dial Line Rate defaultS43 Auto Mode default 1, range S90 S89 Timer to Control Sleep ModeS91 S92 No CarrierResult Code FCC Part 68 Requirements FCC RegulationsDeclaration of Conformity Canadian Department Of Communications Cdoc