Actiontec electronic 56K V.90 manual Connection Completion Time-Out, Comma Dial Modifier Time, S10

S7 Connection Completion Time-Out

Range: 1-255

Default: 50

Units:seconds

This register sets the time, in seconds, that the modem must wait before hanging up because carrier is not detected. The timer is started when the modem finishes dialing (originate), or goes off-hook (answer). In originate mode, the timer is reset upon detection of an answer tone if allowed by country restriction. The timer also specifies the wait for silence time for the @ dial modifier in seconds. S7 is not associated with the W dial modifier.

S8	Comma Dial Modifier Time
Range:	0-65
Default:	2
Units:	seconds

This register sets the time, in seconds, that the modem must pause when it encoun- ters a comma (“,”) in the dial command string.

S10	Automatic Disconnect Delay
Range:	1-254
Default:	20
Units:	0.1 seconds

This register sets the length of time, in tenths of a second, that the modem waits before hanging up after a loss of carrier. This allows for a temporary carrier loss without causing the local modem to disconnect. The actual interval the modem waits before disconnecting is the value in register S10.

S11	DTMF Dialing Speed
Range:	50-150
Default:	95
Units:	0.001 seconds

This register determines the dialing speed which is prefixed for each country.

S12	Escape Guard Time
Range:	0-255
Default:	50
Units:	0.02 seconds

This register sets the value (in 20 ms increments) for the required pause after the escape sequence (default 1s).

69