Actiontec electronic 56K V.90 manual Installing The Modem

Page 8

5.Firmly but gently insert the modem into the available PCI expansion slot. En- sure that the card is seated properly before securing it with the screw removed in Step 4, as shown in the following diagram:

Figure 3: Installing The Modem

6.Put the chassis cover back on the computer.

7.Be sure that all power switches are in the OFF position, then reconnect the power cables to the computer and its peripherals.

8.Connect the telephone line cable to the Line (Telco) jack as shown in Figure 7.

9.Turn on the computer and proceed to the following sections to configure your modem to the operating system you are using.

7

Image 8

Contents 56K V.90 PCI Voice/Fax Windows Modem Table of Contents Introduction For Windows 95 and Windows 98 Installations Do This FirstFor Windows NT 4.0 Installation For Windows 2000 Professional Installation Installing The Modem Hardware InstallationInstalling The Modem Connecting Devices to the Modem Connecting DevicesConfiguring Windows Page Configuring Windows 95B Page Configuring Windows Page Next Page Page Configuring Windows NT Page Page Page Configuring Windows 2000 Professional Page Page Page Page Confirming the Installation of the Driver in Windows Page Installing Communications Software Modem’s Voice FeaturesPage Troubleshooting Windows 95/95B/98More Info Panel Does Not Install Windows NT Common Problems No Dialtone ErrorCan’t Connect at 56K Uninstalling the Modem Uninstalling in Windows 95Ltcom.vxd ltwave.inf Page AT Commands Repeat Last CommandAnswer Command ATXnCarrier Control Echo Command DnDialOnline Data Character Echo Command Hook ControlMonitor Speaker Volume Request ID InformationThis command turns the speaker on or off Modulation HandshakeResult Code Control Return On-line to Data ModeSelect Pulse Dialing DCE Response Format Result Code OptionExtended Result Codes Dial Tone DetectRecall Stored Profile Busy Tone DetectLong Space Disconnect Auto Retrain Data Carrier Detect DCD Control22bis Guard Tone Control Load Factory SettingsDTR Control Local Flow Control Selection Asynchronous Communications ModeAuxiliary Relay option This Command is effective only for use in Japan View Active Configuration and Stored Profile Data Set Ready DSR OptionLSD Zn=x Store Telephone Number Modem Port Flow Control \An\Bn \Kn Same as 4.Default \Nn \Tn Inactivity Timer \Vn Protocol Result Code\Xn XON/XOFF Pass Through Data Calling ToneV90=x Downstream Rate and Control Enable/Disable Data Compression AT Commands for Testing and DebuggingWrite to/Read from DSP Register Line-to-Line LoopbackATI11 XXX Registers Reference TypeAscii Connection Completion Time-Out Comma Dial Modifier TimeS10 S11 Dtmf Dialing SpeedS22 S14 General Bit Mapped Options StatusS21 S24 Timer to Control Sleep Mode S28 Modulation Enable/DisableS30 Inactivity Timer S32S36 S37 Dial Line Rate defaultS35 Data Calling Tone S43 Auto Mode default 1, range S38 56K Dial Line Rate defaultS42 Auto Rate default 1, range S91 S89 Timer to Control Sleep ModeS90 S92 No CarrierResult Code Declaration of Conformity FCC RegulationsFCC Part 68 Requirements Canadian Department Of Communications Cdoc