Aiwa XH-A1000 manual Troubleshooting Guide, To reset

Page 34

COPYRIGHT

Please check the laws on copyright relating to recordings from discs, radio or external tape for the country in which the machine is being used.

The word “BBE” and the “BBE symbol” are trademarks of BBE Sound, Inc.

Under license from BBE sound, Inc.

DOLBY NR

Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation.

“DOLBY” and the double-D symbol hare trademarks of Dolby Laboratories Licensing Corporation.

DOLBY PRO LOGIC

Manufactured under license from Dolby Laboratories Licensing Corporation.

“DOLBY”, the double-D symbol h and “PRO LOGIC” are trademarks of Dolby Laboratories Licensing Corporation.

NOTE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

CAUTION

Modifications or adjustments to this product, which are not expressly approved by the manufacturer, may void the user’s right or authority to operate this product.

To reset

If an unusual condition occurs in the display window or the cassette decks, reset the unit as follows.

1Press POWER to turn off the power.

2Press POWER to turn the power back on while pressing sCLEAR. Everything stored in memory after purchase is

canceled.

If the power cannot be turned off in step 1 because of a malfunction, reset by disconnecting the AC cord, and connect it again. Then carry out step 2.

TROUBLESHOOTING GUIDE

If the unit fails to perform as described in these Operating Instructions, check the following guide.

GENERAL

There is no sound.

•Is the AC cord connected properly?

•Is there a bad connection? (b page 4)

•There may be a short circuit in the speaker terminals.

b Disconnect the AC cord, then correct the speaker connections.

•Was an incorrect function button pressed?

•No sound is heard from the center and surround speakers when the DOLBY PRO LOGIC, the DSP SURROUND system and the 5.1CH are set to off. (b pages 13, 23)

There is no sound from the center and surround speakers when you use the DOLBY PRO LOGIC.

•Are the DSP SURROUND system and the 5.1CH set to off? (b pages 13, 23) )

Sound is emitted from one speaker only.

•Is the other speaker disconnected?

The output sound is not stereo.

•Is the Karaoke function turned on? (b page 26)

An erroneous display or a malfunction occurs. b Reset the unit as stated below.

The unit blacks out when the power is off.

•Is the power economizing mode set to "ECO ON" or "ECO AUTO"? (b page 10)

The power is not turned on.

• Disconnect the AC cord, and connect it again in a few seconds.

TUNER SECTION

There is constant, wave-like static.

•Is the antenna connected properly? (b page 5)

•Is the signal weak?

b Connect an outdoor antenna.

The reception contains noise interferences or the sound is distorted.

•Is the system picking up external noise or multipath distortion? b Change the orientation of the antenna.

b Move the unit away from other electrical appliances.

CASSETTE DECK SECTION

The tape does not run.

• Is the deck in pause mode? (b page 16)

The sound is off-balance or not adequately high.

•Is the playback head dirty? (b page 31)

Recording is not possible.

•Is the erasure prevention tab on the tape broken off? (b page 23)

•Is the recording head dirty? (b page 31)

Erasure is not possible.

•Is the erasure head dirty? (b page 31)

•Is a metal tape being used?

High frequency sound is not emitted.

•Is a tape recorded without Dolby NR played back with the Dolby NR system operating? (b page 16)

•Is the playback head dirty? (b page 31)

CD PLAYER SECTION

The CD player does not play.

•Is the disc correctly placed? (b page 17)

•Is the disc dirty? (b page 31)

•Is the lens affected by condensation?

b Wait approximately one hour and try again.

GENERAL

En

ENGLISH 33

Page 33 Page 35
Image 34
Page 33 Page 35
Contents XH-A1000 Presione qREC/REC Mute para iniciar la grabación Press q REC/REC Mute to start recordingPágina Appuyez sur qREC/REC Mute pour lancer l’enregistrementElectric Power PrecautionsInstallation AC power cordTable of Contents Basic Connections Check Your System AccessoriesBefore connecting the AC cord Connect the right speaker to the main unitPositioning the Speakers Connecting Other Equipments Connecting AN Outdoor AntennaConnection example AUXSelecting External AUDIO/VIDEO Sources Connecting a DVD PlayerPlay the connected equipment Before Operation Remote ControlSetting Display Mode PreparationsBUILT-IN Subwoofer System Setting Power Economizing ModeChannel MULTI-AMPLIFIER System Press ECOBBE System Audio AdjustmentsVolume Control Super T-BASS SystemSelecting the Programmed Equalization Curve Setting a NEW Equalization Curve ManuallyGraphic Equalizer Press GEQMemorizing the NEW Equalization Curves DSP SurroundMulti JOG Press Tuner Preset repeatedly to select Manual tuning mode Manual TuningPress TUNER/BAND repeatedly to select the FM Or AM band Repeat steps 1 Presetting StationsPreset Number Tuning ReceptionBasic Operations Music SensorPlaying Discs To play with the remote controlLoading Discs CD Playing Tape PlaybackRandom Play RANDOM/REPEAT PlayPress RANDOM/REPEAT Repeat PlayBlank Skip Play Programmed PlayPlaying Basic Recording Sound Adjustment During RecordingInserting Blank Spaces Press qREC/REC MUTE, and then press AI Edit RecordingPress CD and load the discs Press CD EDIT/CHECK once Within 2 seconds to start recordingRepeat for the rest of the tracks for side a Press CD and load the discs Press CD EDIT/CHECK twicePress the numbered buttons 0-9 to designate Tape length To check the order of the programmed track numbersPress Dolby PRO Logic to select Normal Adjusting Speaker LevelDolby Surround Recording DolbyTo cancel Dolby PRO Logic mode Press Manual Select again to stop the noise signalTo change the delay time About the channelsSurround Surround SoundAdditional Dolby PRO Logic Modes DolbyMicrophone Mixing Vocal FADER/MULTIPLEX Functions Press CD and load the discs Press Prgm once CD Karaoke ProgramRepeat to reserve other tracks Press d to start play Karake Setting the ClockTimer ClockPress Power to turn off the power Setting the TimerAdjust the volume Prepare the sourceTimer Care and MaintenanceTimer Recording ClockSpecifications Troubleshooting Guide To resetName/Nombre/NomPage/Pá gina/Page Parts IndexName/Nombre/Nom Page/Pá gina/Page Correction Registro del propietario PrecaucionesAdvertencia Instalació nÍndice Conecte el altavoz derecho a la unidad principal Compruebe EL Sistema Y LOS AccesoriosConexiones Básicas Antes de conectar el cable de CAColocació N DE LOS Altavoces Conexió N DE UNA Antena Exterior Ejemplo de conexió n Selecció N DE Fuentes DE AUDIO/ Video Externas Conexión DE UN Reproductor DE DVDEmplee el equipo conectado Control Remoto Ajuste DEL Modo DE Visualizació NSistema DE Altavoz Potenciador DE Graves Incorporado Ajuste DEL Modo DE Ahorro DE EnergíaSistema Multiamplificador DE 4 Canales Presione ECOSistema BBE Control DE VolumenAjustes DE Sonido Sistema Super T-BASSAjuste Manual DE UNA Curva DE Ecualizació N Nueva Ecualizador GráficoSelecció N DE LA Curva DE Ecualizació N Programada Presione GEQEnter Memorizació N DE LAS Curvas DE Ecualizació N NuevasAntes de que transcurran 8 segundos, presione Presione SurroundRecepción DE LA Radio Sintonización ManualEmisora Repita los pasos 1 y Sintonizació N DEL NÚ Mero DEMemorizació N Para borrar emisoras memorizadasSensor DE MÚ Sica Operaciones BásicasReproducción DE Cintas Reproducción DE CD Inserció N DE DiscosReproducció N DE Discos CintasReproducció N Aleatoria Reproducció N ALEATORIA/REPETIDAPresione RANDOM/REPEAT Reproducció N RepetidaPresione Prgm dos veces en el modo de parada Reproducció N CON Omisió N DE Espacios EN BlancoPresione CD Blank Skip en la unidad principal Inserció N DE Espacios EN Blanco Grabación BásicaAjuste DE Sonido Durante LA Grabació N GrabaciónGrabación DE Edición AI Repita el paso 5 para el resto de las pistas de la Cara a Grabación DE Edición ProgramadaProgramar alguna pista Para cambiar el programa de cada caraPresione Dolby PRO Logic para seleccionar Ajuste DEL Nivel DE LOS AltavocesNormal Acerca de los canales Para cancelar el modo Dolby PRO LogicReproducción CON Dolby PRO Logic Para cambiar el tiempo de retardoInicie la reproducció n del sonido Dolby Digital Digital SurroundModos Dolby PRO Logic Adicionales Surround en el reproductor de DVDMezcla DE Sonidos CON Micrófonos Conecte los micró fonos a las tomas MIC 1 y MICVocal Fader Funciones Vocal FADER/MULTIPLEXMultiplex Presione CD e inserte los discos Pulse Prgm una vez DE Apagado Ajuste DEL RelojReloj Y Temporizador Karaoke Ajuste DEL Temporizador Ajuste el volumenPresione Power para desactivar la alimentació n Prepare la fuenteGrabació N CON Temporizador RelojEspecificaciones Guía DE Solución DE ProblemasPara restaurar la unidad Correction Alimentatio AvertissementRé fé rences utilisateur Câ ble d’alimentationTable DES Matieres Raccordez le haut-parleur droit à l’appareil principal Verification DE LA Chaine ET DES AccessoiresRaccordement DE Base Avant de brancher le câ ble d’alimentationPositionnement DES HAUT-PARLEURS Raccordement D’AUTRES Appareils Raccordement D’UNE Antenne ExterieureExemple de raccordement Et la prise d’entrée vidéo Et la prise de sortie vidéoSelection DE Sources AUDIO/VIDEO Externes Raccordement D’UN Lecteur DVDDé marrez la lecture sur l’appareil raccordé Telecommande Reglage DU Mode D’AFFICHAGESysteme D’EXTREMES-GRAVES Integre Reglage DU Mode D’ECONOMIE D’ENERGIESysteme MULTI-AMPLIFICATEUR a 4 Canaux Appuyez sur ECOSysteme BBE Commande DE VolumeReglages Audio Systeme Super T-BASSSelection Manuelle D’UNE Nouvelle Courbe D’EGALISATION Egaliseur GraphiqueSelection DE LA Courbe ’EGALISATION Programmee Appuyez sur GEQSur Enter Memorsonisation DE Nouvelles Courbes D’EGALISATIONDans les 8 secondes, appuyez sur Enter Appuyez sur SurroundSi une é mission FM sté ré o comporte des parasites Mode de syntonisation de pré sé lection Le numéro deSyntonisation Manuelle Pour changer l’intervalle de syntonisation AMRé pé tez les é tapes 1 et Syntonisation D’UN Numero DEPreselection Pour supprimer une station pré sé lectionné eDetecteur DE Musique Pour sé lectionner un mode d’inversionOperations DE Base Types de cassettesCassette Chargement DE DisquesLecture DE Disques Pour reproduire tous les disques du compartimentLecture Aleatoire Lecture ALEATOIRE/REPETEEAppuyez sur RANDOM/REPEAT Lecture RepeteeLecture Avec Saut DES Blancs Appuyez deux fois sur Prgm en mode d’arrê tLecture Programmee LectureReglage DU SON EN Cours ’ENREGISTREMENT Insertion DE BlancsEnregistrement PAR Montage Intelligent Appuyez sur qREC/REC Mute puis appuyerPour changer le programme de chaque face Enregistrement PAR Montage ProgrammePour contrô ler l’ordre de programmation des plages Pour effacer le programme de montageDolby Surround Enregistrement Reglage DU Niveau DES HAUT-PARLEURSAppuyez sur Dolby PRO Logic pour sé lectionner Normal Propos des canaux Pour dé sactiver le mode Dolby PRO LogicLecture EN Dolby PRO Logic Pour changer la duré e de dé calageDolby Digital Mode Dolby PRO Logic AdditionnelsPour sé lectionner le mode Phantom ou 3 Stereo ’affichePour changer la duré e de dé calage de l’é cho Mixage DU MicrophoneAvant de brancher un microphone Lorsque vous n’utilisez pas les microphonesFonctions DE Fondu VOCAL/ Multiplex Programmation D’UN CD Karaoke Horloge ET Programmateur Karaoke Appuyez sur la touche Sleep de la té lé commande’EXTINCTION Appuyez sur Enter ou aReglage DU Programmateur Ré glez le volumeAppuyez sur Power pour mettre l’appareil hors Tension Ensuite sur Enter ou aEnregistrement Programme Amplificateur Appareil principal CX-A1000 Syntoniseur FMSyntoniseur AM Platine à cassetteGuide DE Depannage Ré initialisation
Top Page Image Contents