Chapter 8 | HN9000 Satellite Modem User Guide – | Conformance with standards and directives |
|
|
Operational and safety requirements for Canada
In addition to the warnings and safety guidelines listed in this document, the following operating conditions apply to the modem when used in Canada:
The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective operational and safety requirements. The Department does not guarantee that the equipment will operate to the user’s satisfaction.
Before installing the equipment, users should make sure they are permitted connect to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. In some cases, the company's inside wiring associated with a single line individual service may be extended by means of a certified connector assembly (telephone extension cord). The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations.
Repairs in Canada
Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines, and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.
Users should not attempt to make electrical ground connections themselves, but should contact the appropriate electrical inspection authority, or electrician, as appropriate.
Electromagnetic interference (EMI)
This product conforms to EMI standards of the U.S. FCC and Canadian CSA. To ensure compliance with these standards, installers and users must follow the installation, maintenance, and configuration procedures in the installation guide and user guide.
This is a class B product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.
FCC Part 15
This section applies to the HN9000 satellite modem.
Standards to which Conformity is declared: FCC Part 15
The modem complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Responsible party’s name: Hughes Network System, LLC
62