Self-diagnosis function
This monitor is equipped with a
MENU
1 (power) indicator
If the 1 (power) indicator is green
1Disconnect the video input cable, or turn off the connected computer.
2Press the 1 (power) button to turn the monitor off and on.
3Move the control button , for 2 seconds before the monitor enters power saving mode.
If all three color bars appear (red, green, blue), the monitor is working properly. Reconnect the video input cables and check the condition of your computer.
If the color bars do not appear, there is a potential monitor failure. Inform your authorized Sony dealer of the monitor’s condition.
If the 1 (power) indicator is flashing orange
Press the 1 (power) button to turn the monitor off and on.
If the 1 (power) indicator lights up green, the monitor is working properly.
If the 1 (power) indicator is still flashing, there is a potential monitor failure. Count the number of seconds between orange flashes of the 1 (power) indicator and inform your authorized Sony dealer of the monitor’s condition. Be sure to note the model name and serial number of your monitor. Also note the make and model of your computer and graphic board.
Specifications
CRT | 0.24 mm aperture grille pitch (center) |
| 17 inches measured diagonally |
| |
Viewable image size | Approx. 327 × 243 mm (w/h) |
| (12 7/8 × 9 5/8 inches) |
| 16.0" viewing image |
Resolution |
|
Maximum | Horizontal: 1280 dots |
| Vertical: 1024 lines |
Recommended | Horizontal: 1024 dots |
| Vertical: 768 lines |
Standard image area | Approx. 312 × 234 mm (w/h) |
| (12 3/8 × 9 1/4 inches) |
Deflection frequency* | Horizontal: 30 to 70 kHz |
| Vertical: 48 to 120 Hz |
AC input voltage/current | 220 to 240 V, 50 – 60 Hz, 0.9 A |
Power consumption | Max. 115 W (with no USB devices |
| connected) |
Operating temperature | 10°C to 40°C |
Dimensions | Approx. 460 × 378 × 441 mm (w/h/d) |
| (18 1/8 × 15 × 17 3/8 inches) |
Mass | Approx. 19 kg (41 lb 14 oz) |
Plug and Play | DDC1/DDC2B |
Supplied accessories | See page 6 |
*Recommended horizontal and vertical timing condition
•Horizontal sync width should be more than 1.0 µsec.
•Horizontal blanking width should be more than 3.0 µsec.
•Vertical blanking width should be more than 500 µsec.
Design and specifications are subject to change without notice.
16