Dell 1900 owner manual Sataa connector Satab connector Installing System Components

3Install the hard-drive bay. See Figure 3-10:

a Slide the hard-drive bay into the system until the drive bay contacts the system. b Install the four screws that secure the drive bay to the system.

4Depending on your hard-drive configuration, connect the hard-drive interface and power cables as follows:

•For up to two SATA drives, connect the cables to the two SATA connectors on the system board. SATA_A is the blue connector, and SATA_B is the black connector. Route the cables through the center fan retention cage. See Figure 3-12 for connector location and cabling guidance.

Figure 3-12. Two-Hard-Drive Configuration (Integrated SATA on System Board)

6

5

4 1

2

3

1	center fan retention cage	2	power cable connector	3	hard drive interface cable
					connector
4	hard drive interface connector	5	SATA_A connector	6	SATA_B connector

62

Installing System Components