Matrox Electronic Systems LX G450, LE G450 FCC Compliance Statement, Vcci Compliance Statement

Page 62

USA

FCC Compliance Statement

Remark for the Matrox hardware products supported by this guide These devices have been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna • Increase the separation between the equipment and receiver • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected • Consult the dealer or an experienced radio/TV technician for help.

WARNING Changes or modifications to this unit not expressly approved by the party responsible for the compliance could void the user’s authority to operate this equipment. The use of shielded cables for connection of the monitor to the card is required to meet FCC requirements.

Declaration of conformity of a Class B digital device according to the FCC rules

We, the Responsible Party Matrox, 1075 Broken Sound Parkway, Boca Raton, FL 33487 • Telephone: (561) 989-9626

Attention: Conformity Group Matrox

Declaration The Matrox hardware products supported by this guide comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) these devices may not cause harmful interference, and (2) these devices must accept any interference received, including interference that may cause undesired operation. Any question regarding this declaration should be forwarded to the above coordinates.

CANADA

(English) Industry Canada Compliance Statement

Remark for the Matrox hardware products supported by this guide These digital devices do not exceed the Class

B limits for radio noise emission from digital devices set out in the Radio Interference Regulation of Industry Canada.

(Français) Conformité avec les exigences du ministère de l’Industrie Canada

Remarque sur les produits matériels Matrox couverts par ce guide Ces appareils numériques n’émettent aucun bruit radioélectrique dépassant les limites applicables aux appareils numériques de Classe B prescrites dans le Règlement sur le brouillage radioélectrique édicté par Industrie Canada.

JAPAN

VCCI Compliance Statement

Remark for the Matrox hardware products supported by this guide These are Class B products based on the standard of the Voluntary Control Council for Interference from Information Technology Equipment

(VCCI). If these are used near a radio or television receiver in a domestic environment, they may cause radio interference. Install and use the equipment according to instructions in the manual.

Image 62
Contents English Open your computer and remove your existing graphics card Hardware installationSwitch to the standard VGA display driver Remove the cover for the slot you intend to use Choose an expansion slotInsert your Matrox card DVI/HD-15 a DVI white and an HD-15 Blue connector Connection setupHD-15 only only an HD-15 blue Connector DVI only only a DVI white connectorDVI connector HD-15 connectorDVI connector DVI-to-HD15 adapter HD-15 connector Matrox Graphics Card User GuideMain Connector HD-15 connector analogDetermining your main and secondary display Software installation Set up your display software See Display setup,Monitor setup Display setupAccessing PowerDesk property sheets If you have a Plug-and-Play monitor DualHead Multi-Display setupWindows NT 4.0 analog monitors only If you don’t have a Plug-and-Play monitorWindows 98/Me/2000/XP Other DualHead featuresWindows 98/Me/2000/XP or NT More PowerDesk information For more information on Matrox PowerDeskRestarting in safe mode TroubleshootingBasic procedures Windows 98/MeMain troubleshooting CauseYour monitor manual Make sure the monitor power cable is firmly in placeYour monitor video controls may be improperly set Your monitor may not be properly connectedSolution Windows 98/Me/2000/XP Bayonet Nut Connect BNCRestore your original display settings see steps 2 Matrox Graphics Card User Guide More information Turn off computer Connection setupTV output Attach TV adapterVideo cable TV or video Recorder using VideoConnect video output TV adapterConnect audio output Scart connectorScart adapter TV or video RecorderSoftware setup Extra troubleshooting GraphicsMatrox Graphics Card User Guide Problem Monitor settings aren’t automatically detected BNC Bayonet Nut Connect HD-15 connector Connectors Type of problem is displayed in the General tab Solution Change settings in your computer Bios setup utility Click the plus sign next to Other devices if it appears Matrox Graphics Card User Guide Restart your computer for changes to take effect Windows 2000/XP Click EnableWindows 98/Me Click Close # Yes Multi-display mode, displays aren’t numbered consecutively Disable one or more features Windows XPClick OK # OK to accept the changes Disable Matrox hardware accelerationProgram window or dialog box doesn’t appear on screen Dialog box you want to seeWindows* 2000/XP or NT Solution Disable the displayWindows* 98/Me/2000/XP Solution Windows 2000/XP or NT Use CenterPOPUP Windows 2000/XPProblem Video file playback is jerky skipping frames VideoClick OK to accept the changes Can’t view video Can’t play certain DVD videos TV outputDVD video playback is jerky skipping frames Can’t record DVD videoProblem Computer text is hard to read with a TV Solution Windows 98/Me/2000/XP or NT 4.0 See Software setup,Video appears stretched or squished on a TV Poor TV or video recorder image qualityCan’t record video with a video recorder Windows 98/Me/2000 SoundSelect the aspect ratio of your TV 43 or 169 most TVs are Double-click the speaker icon on the taskbarClick OK Double-click the speaker icon on the taskbar Display information Aspect ratio Main display*† Secondary display† Maximum display resolutionMaximum vertical refresh rate Hz Aspect ratio Display Main display Secondary display†Display Colors Maximum horizontal refresh rate kHzSupported Vesa modes main display Hardware information FeaturesEnvironmental specifications 90 in. / 14.98 cm 25 in. / 8.26 cm Maximum card dimensions for ATX cardsDigital monitor information certain models only Pin Signal Maximum card dimensions for low-profile cardsPinouts for analog HD-15 connector In. / 16.77 cm 54 in. /6.45 cmPin usage for a digital DVI-I connector Certain models only See TV output,Pin usage with an analog dual-monitor cable DVI-I to HD-15 Certain models onlyMatrox Web and FTP sites If you have a problemCustomer support Program specific problems Information we needWhere to get information For display informationWarranty Limited Warranty StatementLimitations of Liability Software license agreement Index 15, 19Thank you for choosing Matrox Vcci Compliance Statement FCC Compliance StatementEnglish Industry Canada Compliance Statement Europe Avertissement sur l’épilepsie DualHead, Matrox, Matrox Mystique, Rainbow Runner English Disclaimer Italia Matrox Graphics IncUnited Kingdom Deutschland