Minolta Pi3505e/PS service manual Mode Factory Setting 355 Bit HEX20

Mode

Factory Setting

355

7

6

5

4

3

2

1

0

Bit:

0

0

1

1

0

0

0

0

HEX:20

Bit

Feature

Logical Value

Description

0

1

7 – 6

Switching between 10 Mbps and

Bit 7-6:

00

Auto-negotiate

• Auto-negotiate setting:

100 Mbps:

01

Fixed at 100 Mbps

Automatically distinguishes

Specifies the communication speed

between 10BASE-T and

10

Fixed at 10 Mbps

for the LAN adapter.

100BASE-TX, and deter-

(network function)

✽

11

Do not specify this

mines the communication

setting.

speed.

• Fixed at 100 Mbps:

Specifies a connection

fixed at 100BASE-TX.

• Fixed at 10 Mbps:

Specifies a connection

fixed at 10BASE-T.

• The settings are applied

after the copier is turned

off, then on again.

5

Switching between full duplex and

Full

Half

Available when bits 7 and 6 of mode 355 are set

half duplex:

duplex

duplex

to “Fixed at 100 Mbps” or “Fixed at 10 Mbps”.

Specifies the packet transmission

• Full duplex setting:

when connected to a switch.

Transmission and reception of packets are per-

(network function)

✽

formed simultaneously.

• Half duplex setting:

Transmission and reception of packets are per-

formed separately.

The settings are applied after the copier is turned

off, then on again.

4

Automatic acquisition of IP address

No

Yes

DHCP

✽

3 – 0

Fixed

Do not change these settings.

✽1 With “Fixed at 100 Mbps” and “Fixed at 10 Mbps”, if the communication speed is not correctly set, communication will not be performed correctly. Check the communication speed of the recipient, and make sure that the correct setting is selected.

Note: Features marked with asterisks can be specified by the user. ✽ indicates screen settings.

S-6