Minolta Pi3505e/PS service manual Overhead projector Transparency inter

Num-	Symptom		Possible Cause	Remedy	Description
ber
29	Stapling can-	The optional finisher		Check that the fin-	In order to specify sta-
	not be speci-	is not installed, or		isher is installed,	pling, the optional fin-
	fied.	the finisher is not		and check the	isher must be installed. In
		selected on the		selected settings	addition, stapling cannot
		Device Options Set-		on the Device	be specified unless the
		ting tab.		Options Setting	finisher is selected on the
				tab.	Device Options Setting
					tab.
		•	The paper size	Check the paper
			setting is smaller	size setting, and
			than the standard	check if the “Book-
			size, such as for	let Creation” set-
			postcards or enve-	ting or the “OHP
			lopes.	Interleaving” func-
		•	Booklet binding or	tion is selected.
			overhead projector
			transparency inter-
			leaving is speci-
			fied.
30	Stapling is	Thick paper or over-		Check the paper
	not per-	head projector trans-		type.
	formed as	parencies are used.
	specified.
		•	The number of	Check the number
			copies exceeds 50	of copies and the
			pages.	paper size.
		• Paper with differ-
			ent sizes are com-
			bined.
		Stapling will be par-		Check the direc-	Staples cannot be
		allel to the paper		tion that the paper	punched parallel to the
		feed direction.		is loaded.	feeding direction. For
					example, when printing a
					landscape document on
					A4 paper in the portrait
					orientation, staples can-
					not be punched at the top
					of the page.
					The stapling position for a
					single staple, as a rule, is
					in the upper-left corner of
					paper loaded in the land-
					scape orientation.

T-10