Minolta Pi3505e/PS service manual Removing the expansion hard disk drive

Page 27

(4)Removing the expansion hard disk drive

4599U035AA

4599U041AA

1.Remove the upper rear cover, the rear cover, the I/F CLAN circuit board cover, the reinforcing plate and the connector bracket.

2.Disconnect the connector from CN4 on the CLAN circuit board.

3.Disconnect the copier's relay harness from the wire holder.

NOTE

Harness types differ between those for copiers and those for fax machines.

4599U039AA

4599U023AC

4.Remove the mechanical circuit board cover (5 screws).

NOTE

Make sure that the harness on the right side of the mechanical circuit board cover is not pinched.

5.Disconnect the flat cable from the hard disk drive. ✽ When connecting the flat cable to the hard disk

drive, align the cable with the side of the hard disk drive marked with ▼, and then connect the flat cable.

NOTE

•Connect the flat cable so that the yellow line is on the left side of the hard disk drive.

•Four pins on the left side of the hard disk drive remain free.

D-6

Image 27

Contents Pi3505e Pi3505e/PS Always observe precautions Safety Precautions for Inspection and ServiceDo not work with wet hands Do not throw toner or the toner bottle into a fireUse the specified parts Be careful with the high-voltage partsMaintain a grounded connection at all times Do not touch a high-temperature partRestore all parts and harnesses to their original positions Precautions for Service JobsPrecautions for Servicing with Covers and Parts Removed Precautions for the Working EnvironmentPrecautions for storing the toner or imaging cartridge Vorsicht Used Batteries PrecautionsALL Areas GermanyHow to Use this Book Other PrecautionsPrecautions for Service Precautions Before ServiceHandling of Other Parts Precautions for Dis/ReassemblyPrecautions for Circuit Inspection Handling of PWBs During Transportation/StorageHandling of the PC Drum Handling of the Imaging Cartridge and Print Unit Page Contents Page General MECHANICAL/ELECTRICAL Page Controller Specificationss SpecificationsApple Macintosh Computers Pi3505e/PS only Supporting Client SpecificationsIBM PC and Compatible Computers CPUFunctions Function Overview of Circuit BoardsClan circuit board OverviewLAN is not connected correctly LED indicatorsBlock Diagram Copier has not been turned onDIS/REASSEMBLY Adjustment Page DISASSEMBLY/REASSEMBLY Removing partsRemoving the copier covers Remove the reinforcing plate 4 screws Remove the connector bracket 1 screwRemoving the Clan circuit board CN4CN5 Remove the Clan circuit board CN3 Expansion slot 1 CN4Expansion slot 2 CN5 Removing the expansion hard disk drive CN2 CN1Checking the assembly Remove the Compact Flash cardChecking the operation of the printer controller DISPLAYS/SETTINGS Page Printer controller/Network interface unit Checking Touch Panel DisplaysController Network Setting Assigning the IP AddressStarting PageScope Light Soft Switch Changing soft switch settingsDisplaying the setting screen from Tech. Rep. Mode Page Specifying Printer Function Soft Switch Settings Soft switch settingsBit Mode Factory Setting 355 Bit HEX20Mode Factory Setting Bit HEX04Bit HEX05 North America Mode Factory Setting 440 Bit HEX12Bit HEX80 Bit HEX01Bit HEX00 Bit 000000 Courier Mode Factory Setting 444 Bit HEX00HEX5C Mode Factory Setting 445 BitMode Factory Setting 449 Bit HEX00 HEX3CBit HEX30 Bit HEX03 HEXE8HEX8C HEX0FBit HEX23 Page Troubleshooting Page Problems While Printing from a Computer Computer printing problemsNections so that a Printer buffer Switch is not being Used Reduced As overlapping images Drawer, depending on May not be applied Properties dialog boxPrinter’s Properties Ever, depending onApplication, the printing Orientation selected fromCopier to be printed Correctly, refer to Copies is Specified from Copy by usingHas priority differs Copies are not printedOrder to specify booklet Type and size Overhead projector trans Specified Tation, holes cannot bePunched at the top Overhead projector Transparency inter Num Symptom Possible Cause Remedy Description Ber Cover Orientation settings speciSpecify the paper Inter Interleaves or Warm restart operation Warm restart procedureWarm Restart Overview7662-4513-11 Copyright