Minolta Pi3505e/PS service manual Drawer, depending on

Num-	Symptom	Possible Cause	Remedy	Description
ber
7	Data was	The specifically	Use the specifi-	If the print data cannot be
	sent, but	designed printer	cally designed	received correctly, stop
	could not be	driver was not used.	printer driver.	printing.
	printed, or
		The correct cable is	Check the cable.
	printing did
		not used, or the
	not begin for
		cable is not correctly
	a long time.
		connected.
		Data transmission	Wait a little while	Since this unit is a page
		was not finished.	longer.	printer, if the data for one
				page is incomplete, print-
				ing will not begin. In addi-
				tion, if a large amount of
				data is being sent in the
				graphics mode, data
				transmission takes some
				time.
		The print port for the	Check the print
		driver is incorrect.	port on the Ports
			tab (Windows
			2000/XP/NT 4.0)
			or General tab
			(Windows 98/Me)
		This unit is not	Select this unit as
		selected as the	the default printer.
		default printer.
		The print queue is	Continue the
		temporarily paused	queue or set the
		or is offline.	copier online.
8	No paper is	There is no paper, or	If a message
	fed out.	there is no paper of	appears, indicating
		the specified size.	that the paper
			must be replen-
			ished, load the
			paper.
		Mailbox printing has		Paper is not fed out if
		been specified.		mailbox printing has been
				specified.
9	Paper of the	The paper drawer		When specifying a paper
	specified	has been specified.		drawer, depending on the
	size is			settings for the selected
	loaded, but			paper drawer, do not
	printing is not			select paper in a drawer
	performed.			with different settings.

T-3