Ultra electronic Prima 3 user manual Retransfer mode setting

(to the next page)

Retransfer mode setting

Change settings according to the retransfer film and card used.

> R e t r a n s f e r >

EXIT	Exit user	�
	mode.

ENTER			Set retransfer film	Set film type
> > M e d i a	T y p e		Two types of frame settings (1000 or 750 frames per film)
S t d ( 1 0 0 0 / r o l l ) : 0			• Set to adjust the retransfer film specification.
EXIT	MENU	Press	to select the setting and pressENTER		to save.
			(The electronic beep sounds .The
			beep will not sound if the buzzer mode setting is set to off.)
			Set the retransfer temperature.	6 gradations can be set
> > T e m p . L e v e l			(from –3 or +2, the larger the value the higher the temperature)
	0 ( S t a n d a r d )		• Retransfer may be not performed well depending on the
			cards. Increase the temperature level step by step until the
EXIT			card can be printed clearly.
		Press	to select the setting value and press		ENTER
		to save.	(The electronic beep sounds .The beep will
	MENU
			not sound if the buzzer mode setting is set to off.)
			• Transferability to the cardimproves if the retransfer roller temperature
			is higher.However,high heat will distort the card further
			• If you are not initializing the unit after changing the temperature
			settings, perform temperature control after printing has started.
> > S p e e d ( F r o n t )			Set the retransfer speed:	13 gradations can be set
			(from –10 to +2, the larger the value the faster the speed)
		- 2
			• Partial incompletion may occur depending on the cards
			during retransfer. The performance is increased as the
	MENU		value is lowered. Specify the value mainly on the retransfer
EXIT			roller temperature setting and use the speed setting for
			fine adjustments.

Press to select the setting value and pressENTER to save.

(The electronic beep sounds .The beep will not sound if the buzzer mode setting is set to off.)

> > S p e e d	( B a c k )	Set the reverse retransfer speed:	13 gradations can be set
	- 2	(from –10 to +2, the higher the value the faster the speed.)
		• Double-sided printing results in a warp depending on the
EXIT	MENU	cards. When this happens, set the speed to 1step faster from
		the surface side.
	Press		ENTER	to save.
		to select the setting value and press
		(The electronic beep sounds .The beep will not sound if the buzzer
		mode setting is set to off.)

> > M G P r i n t ( J I S )			Set the way of the peeling off the retransfer film
			2 settings[On and Off]
	Off		Depending on the card used,peeling off the retransfer film may not be
			complete.
EXIT	MENU		For the cards with JIS magnetic stripes,setting "On" is recommended.
		• When setting "On",printing time will be longer by about1,5s
		• No improvement is expected for the cards with ISO magnetic stripes.

ENTER

Press to select the setting value and press to save.

			(The electronic beep sounds .The beep will not sound if the buzzer
			mode setting is set to off.)			2 settings[Front Wait and Back Wait]
> > S t a n d b y	M o d e			Laminate Standby selection:
	Front Wait			In case of both side printing with lamination unit connected,
				select either one of the card sides for standby.
EXIT	MENU				to select the setting value and press		ENTER
		Press					to save.
		(The electronic beep sounds .The beep will not sound if the buzzer

mode setting is set to off.)

33