Ultra electronic Prima 3 Card Thickness setting mode IC contact setting mode, Test print

	Operation	(continued)
	Card Thickness setting mode						IC contact setting mode
The printer is designed to load only the 0.76mm or 0.25mm						When using IC cards, specify the contact position to
thick cards. So set card thickness depending on the card						stop the cards.
used.									EXIT
			EXIT			> I C C o n t a c t	P o s .
	> C a r d T h i c k n e s s
				Exit user mode				N o n e		Exit user mode
		S t a n a r d
						Set IC contact
Set the card thickness:
						position:
2 settings
						3 settings
[Standard and Thin]
				ENTER						ENTER
	Press	to select the setting and press			to save. Press			to select the setting and press			to save.
	(The electronic beep sounds.The beep will not sound					(The electronic beep sounds.The beep will not sound
	if the buzzer mode setting is set to off.)					if the buzzer mode setting is set to off.)

Standard: 0.76mm(0.03inches)-thick

Thin: 0.25mm(0.01inches)-thick

For changing card thickness, see “switching the card thickness” on Page 21 of this manual

None

No contact

Ext. Unit

An IC unit contact is being used

Built-in

A built-in contact is being used

Coercivity setting mode

Set coercivity for writing data on the ISO compatible magnetic stripe card.

> M G I S O T y p e	EXIT
	Exit user mode
	L o - C o
	ENTER
Press	to select the setting and press	to save.

(The electronic beep sounds.The beep will not sound if the buzzer mode setting is set to off.)

Lo-Co

238⋅ 102 [A/m] (300 [Oe])

Hi-Co

218⋅ 103 [A/m] (2750 [Oe])

Non-contact IC antenna setting mode

To use non-contact IC cards, set the antenna position at which the cards stop.

> I C A n t e n n a P o s . EXIT

Exit user mode

N o n e

Non-contact IC antenna position:

3 settings

ENTER

Pressto select the setting and press to save.

(The electronic beep sounds.The beep will not sound if the buzzer mode setting is set to off.)

None

No antenna

Ext. Unit

An IC unit antenna is being used

Added on

A compact IC unit is being used.

Test print

Test print is provided for printing a test pattern contained in the printer (there is only one pattern). Operating the printer independent of the host computer enables you to find out the source of trouble if there is a problem in the system.

> T e s t P r i n t EXIT

Exit user mode

O K ?

ENTER

Press to carry out test printing.

(The electronic beep sounds.The beep will not sound if the buzzer mode setting is set to off.)

P r i n t i n g . .

A single-sided color pattern is printed. When test printing is completed, the unit will automatically return to ready status.

				Unit No. Setting
	Set Unit Number of the printers to be connected
					EXIT
	> U n i t N o .
				N o . 1		Exit user mode
	Unit No:
	7 settings
						ENTER
	Press			to select the setting and press			to save.
				(The electronic beep sounds.The beep will not
			EXIT	sound if the buzzer mode setting is set to off.)
After that press				,Then the message is displayed as shown below.
					Turn off the power
		P l e a s e ,
					And then by turning on the power,
		P o w e r O f f			Unit No. setting mode is cancelled.

36