Ultra electronic Prima 3 Set position of MAC address print, Low temperature stand-by mode setting

Set position of MAC address print

In the case of UV print, MAC address must be printed at the edge of a card at the same time. Position of MAC address is selectable between Right Upper Edge or Left Bottom Edge via Command or opration panel. Please refer to following picture 1 about print position. Following mentioned coordinates are based

on “Starting point of Print Area” and indicated in pixels.

	Starting Point of
	Print Area(0,0)
B
(42,611)
Print position of MAC	-90AB
address in case
that it is set at	5678-
Lower Left position.	1234
	(764,18)
	A

Direction of Retransfer
			1234-		230
	Print	position of MAC address	5678-
					Pixel
	in case that it is set at			90AB
	Upper Right position.

34

Pixel

(1035,663)

Fig. 1 Print Position of MAC address

CAUTION

In case that UV is printed on YMC directly, print error will be occurred when retransferring. So in case that YMC image is overlapped with UV image, please print UV image on the retransfer film after YMC image is retransferred on the card. It is requested to pay the same special attention for MAC address that is printed with UV ink.

So in case that MAC address print area with UV ink is overlapped with with YMC-K image, please print UV image on the retransfer film after YMC-K ˆimage is retransferred on the card.

Low temperature stand-by mode setting

Please set ON normally in this mode. When the printer is set ON in this mode, the printer will become standby at low temperature of the retransfer heat roller after no printing motion for 30 minutes and over. The temperature of the heat roller will automatically get an original setting when next card printing command received. For that reason, it takes long time for 1st card compared with normal printing.

Availability of heat roller control at the re-transfer side.(on,off)

> H R C o n t r o l		EXIT	Exit user
	o f f		mode.
Press			ENTER	to save.
	to select the setting press

(The electronic beep sounds .The beep will not sound if the buzzer mode setting is set to off.)

DOWNLOAD mode setting

Set the printer to DOWNLOAD mode.

CAUTION When data is transferring from thee host computer, “Downloading” will be displayed

If the power is turned off at this time, the printer firmware will crash and the printer cannot operate.

	> D o w n l o a d			EXIT	Exit user mode
			O K ?
					EXIT
ENTER		Press ENTER key to set DOWNLOAD mode.
		(The electronic beep sounds, The beep will not
		sound if the buzzer mode setting to off)
	> D o w n l o a d R e a d y			EXIT	> D o w n l o a d i n g >
					P o w e r O f f
			Start
	Completion			When data is received from the Host
	> D o w n l o a d i n g
				computer,Downloading will be displayed.
		K e e p p o w e r O n

	Transport mode
To set the transport mode.
		EXIT
> T r a n s p o r t m o d e
	O K ?		Exit user mode
ENTER	to carry out transport mode.
Press
	(The electronic beep sounds.The beep will not
	sound if the buzzer mode setting is set to off.)
P l e a s e ,		Please turn off the power.
P o w e r o f f		Turning on the power, then the
		transport mode is canceled.

CAUTION

When shipping or moving the printer, you must set the transport mode. If the printer is not set

the transport mode, it may have a damage.

39