Ultra electronic Prima 3 user manual Turning off the power, About the Reset button, Is loaded

Operation (continued)

CAUTION

When the printer was occurred an

error during printing operation caused by above- mentioned operation or others, the retransfer film was rewinded about 3 panels. If the printer is turned off and on

the power or is initialized, the printer occur the printing an error which is “INK RUNOUT” or print results problem because of the printer try to print the used retransfer film. Wind up the retransfer film about 3 panels by unused

panel. See p.18 “Caution when loading the retransfer film cassette and/or the ink ribbon cassette” and p.26 “On initialization when the retransfer film cassette and/or the ink ribbon cassette is loaded”.

Turning off the power

1. Check the printer status.

In ready, preheat or error status, check that printer operations are suspended.

2. Turn off the power.

Always wait 10 seconds or more before turning the power back on again.

Turn off the power switch when you won’t use the printer for a prolonged period of time for power saving.

About the RESET button

On Initialization when the retransfer film cassette and/or the ink ribbon cassette

is loaded

Dust or foreign particles may attach on the surface of retransfer film and ink ribbon when their cassette are removed from the printer.

This may cause defective printing such as image void, defective retransfer etc.

To Avoid this, it is recommended that the retransfer film and the ink ribbon are wound up one or two panels after they are reloaded.

Please follow the initialization procedure described below:

1. Turn the power switch on, and wait until the LCD panel displays “Preheat” or “Ready”.

2.		RESET	key.
	Depress the
	LCD panel displays:
		I n i t i a l i z e
				O K ?
3.
	By depressing the			key or the	key, the

LCD panel change accordingly as shown below. Select the wind-up condition, one or two panels. (This set up is not memorized.)

I n i t i a l i z e

2 ' n d P a n e l , O K ?

When an error occurs in the printer, press the

button, then the ENTER button.

RESET

•	Initialized after two panels of the retransfer film
	and the ink ribbon are would up.

The printer is initialized with this operation.

If the error still persists, see p.46-47 and take the

appropriate actions.

Then, press the RESET button, and the ENTER button

again. The printer is initialized, and returns to the

“Ready” state.

(When you turn off the power, these procedures are not

necessary.)

I n i t i a l i z e

N E X T P a n e l , O K ?

•Initialized after one panels of the retransfer film and the ink ribbon are would up.

I n i t i a l i z e

O K ?

•Initialized without winding up. (Default)

4. By depressing the ENTER key, the printer is

initialized according to the selected above set up condition.

26