
GENERAL INFORMATION
IF YOU MAKE A MISTAKE...
If, during a programming session, you find that you are unsure of the scanner's settings or wish to
Appendix A contains a complete list of all standard factory settings.
WARNING
After returning the scanner to factory de- faults, you must scan the BASE STATION I.D. label (located on labels on the top and side of the base station) and the CONFIGURATION UPLOAD label as described below. This will reestablish the communication link between the scanner and base station, and complete the restoration of the scanner's original con- figuration.
RETURN TO FACTORY SETTINGS
Scan this label to return the scanner to the factory settings for the active interface. It is unneccessary to scan “set” and “end” labels with this label.
CONFIGURATION UPLOAD
Use this option to upload the configuration file from the base station to the scanner.
SET -------------------------------------
UPLOAD BASE STATION CONFIG -
END -------------------------------------
6 | SP400RF Programming Guide |