Scanning
1.After programming frequencies, simply press SCAN to begin scanning. During scanning, when you rotate the
VFO, you can select the direction (↑ or ↓) you want to scan.
SCAN | C 001 |
| |
Bank | 1234567890 |
2.The bank indicators selected for scanning appear on the display, and the bank being currently monitored flashes. You can deselect banks from active scanning by entering their number on your keypad. The indicator for each deselected bank disappears, and the bank’s channels are not scanned.
Note: One bank must always be active. You cannot deactivate all ten banks at the same time. If you try to deselect all the banks, the first bank is automatically selected.
To restore a bank to active scanning, enter the bank’s number on your keypad.
The bank’s indicator will display again.
3.During normal scanning the scanner skips unprogrammed or locked out channels.
SCAN
CHANNELS 1 2 3 4 5 6 7 8 9 10
4.When a transmission is received, the scanner stops on that channel. When the transmission ends, scanning resumes automatically.
Another method is as follows:
1.Press HOLD/MAN.
Frequency | Frequency |
Locked Out | not entered |
(L/O) |
|
2.While the VFO setting is in the channel mode, rotate the VFO until the desired channel is displayed.
Note: When in Hold mode, you can use the VFO to step up or down through the channels. You can also switch from stepping up/down through channels to stepping up/down through frequencies by pressing the HOLD/MAN button for 2 seconds.
Storing Frequencies During Scanning
During Scanning
1.Press HOLD/MAN.
31