2.Press TRNSFR, and the smallest empty channel number flashes on the display.
3.Press E.
Note: • If you want to change the channel, rotate the VFO.
CH/ |
|
|
FRQ |
|
|
HOLD/ |
| RSM |
MAN |
| |
SCAN | AIR/STEP | SEARCH |
MENU/BACK |
| TRUNK |
L/O
REVERSESELECT
.E
•If the frequency you want to store exists already, WARNING appears on the display and you will hear a beep. (See “Duplicate Frequency Alert” on page 27).
RF Attenuation Feature
The UBC3300XLT comes with an RF Attenuation feature. If you're near an unusually strong signal source, the signal may overload the scanner. The scanner may stop repeatedly on that signal and miss other transmissions.
The RF Attenuation feature works in all modes and attenuates (reduces) the incoming signal strength to prevent stronger signals from overloading the scanner.
The RF attenuation is set at the Menu mode.
1.Press MENU/BACK.
2.For Search mode, select 1:SERVICE OPTION /
2:CHAIN SEARCH/4:ATTENUATOR / 1:ON by rotating the VFO and pressing E.
OR
For Scan mode, select 2:SCAN OPTION / 1:CONVENTIONAL by rotating the VFO and pressing E. Then select the channel number by rotating the VFO and pressing E. Select 5:ATTENUATOR by rotating the VFO and pressing E.
3. Select 1:ON by rotating the VFO and pressing E.
Note: Attenuation will only be active for the specified channel. In Search mode, it is applied to the search ranges in all banks.
Setting the Delay Mode for Frequency
The delay of 2 seconds is automatically set for each frequency. To set the delay feature, enter into the Menu mode.
1.Press MENU/BACK.
2.For Scan mode, select 2:SCAN OPTION /
32