Caution: After you have entered the search range while still in the Menu mode, you can set your alpha tag (see page 28), change the step size of the search, change the mode or change the trunk set.
Once the lower and upper parameters of your search are edited, the Menu screen backs up one level to allow you to modify the step size, receive mode, and alpha tag. Select 2:STEPS for your step size choices and then press E.
Select 3:MODE for the receiver mode choices and then press E. Select 4:ALPHA TAG to enter an alpha tag using the VFO and then pressing E.
Select 5:TRUNK to switch ON or OFF for trunk search.
Starting Chain Search
1.After setting the search ranges, select 1:SERVICE OPTION / 2:CHAIN SEARCH / 1:CHAIN SEARCH by rotating the VFO and pressing E.
2.Select 1:ON by rotating the VFO and pressing E.
3.Press SEARCH to search up to 10 ranges continuously.
Note: • If CHAIN SEARCH is OFF, only 1 range can be searched.
•When searching stops, press RSM to resume searching.
•When you rotate the VFO while searching, you can change the search direction to up or down.
•When searching in WFM, it will stop before reaching the desired frequency if the step is other than 50 kHz or 100 kHz.
Search Hold Feature
1.Press HOLD/MAN at anytime to stop the search.
2.Press RSM or SEARCH to resume searching.
SRCH 12.5k
1240.0000 FM
Range 1
25cm Amateur Grp
Data Skip
A scanner will normally stop on any transmission it receives. This means the UBC3300XLT will occasionally stop on data signals and unmodulated transmissions. You can automatically skip many of these types of transmissions during search. To activate the Data Skip feature, enter into the Menu mode.
37