Outback Power Systems Press the DC soft key to view the status of the FlexNet DC, Readings

Page 19

FX Total

 

12.6V

99%

Inverting

 

 

0.000kW

AC Loads

 

 

0.000kW

Buying

$

 

0.000kW

From the MAIN menu, press the <SUM> soft key to view a summary of the system’s operation. This information is a sum of all FlexNet DC data. Press the second soft key to view the next SUM screen

DC BAT

 

12.5V 99%

Bat

-0.6A

0.000kW

Net

-4AH

00.7kWH

Days Since Full

4.8

MAIN------------------------------

11:30:55A

SUM STATUS SETUP ADV

STATUS choose device:

FX CC DC MAIN

The fourth SUM screen shows:

Battery voltage

The current state-of-charge

Battery readings show the instantaneous amp, amp hour, kilowatt, and kilowatt hour figures. When comparing the amp hours reading to “FULL,” the figure is charge factor compensated.

The number of days since the battery last met the charge parameters.

Press the first soft key to return to the MAIN screen.

Press the <STATUS> soft key to open the STATUS screen to view the status of either the FX, Charge Controller, or (FLEXnet) DC

Press the <DC> soft key to view the status of the (FlexNet) DC

STATUS/DC/PAGE1 --------------

Press the <METER> soft key to view the (FlexNet) DC meter

STATS

readings.

METER SHUNT BATT TOP

 

18

Image 19
Contents NetTM DC About OutBack Power Systems WarrantyFLEXnet DC User’s Guide 2007 All rights reserved January DisclaimerDate and Revision Contact InformationTable of Contents Introduction OutBack Power Systems FLEXnet DCSystem Overview Reading the FLEXnet DC Postion wiring blockFLEXNet DC package includes Installing the FLEXnet DCConnect each twisted pair to a shunt Torque Values Wiring Block ConnectionsWhite to BAT Black to BAT + Installing the FLEXnet DC Maximum amp charged Maximum battery voltageFLEXNet DC Measurements KiloWattsLogged Data User Adjustable Set PointsData Logging Programming and Using the Mate for FLEXNet DC Operations Typical charge cycle All unused channels should be set to disabledFLEXNet DC Modes Charge CycleGreen Yellow RED Invert Logic Hi Set Point Satisfied Auto ModeProgramming the Auxiliary Relay Relay LogicMate Screens Readings Press the DC soft key to view the status of the FlexNet DCDown Status STATUS/FN Stats Meter Shunt Batt TOP STATUS/DC/SHUNT a Down UP Reset Down UP Reset TOP STATUS/DC/BATT UP TOP Status ADV BAT Shunt PG2 Press the ADV soft key Press the DC soft key Press the Charge soft keyPG1 Charge AUX PG3 ADV/DC/AUX Control ADV/DC/AUX SOC LOW PG2 Reset CLR Main Technical Notes Battery Charge Factor BCFFLEXnet Products Year Limited WarrantyRevision.2007-08-29 Outback Power Systems Inc 19009 62nd Ave. NE Limited Warranty RegistrationREV B