Outback Power Systems DC manual Year Limited Warranty, FLEXnet Products

Page 31

2-Year Limited Warranty

FLEXnet Products

OutBack Power Systems, Inc. (“OutBack”) provides a two year (2) limited warranty (“Warranty”) against defects in materials and workmanship for its FLEXnet products (“Products”) if installed in fixed location applications.

For this Warranty to be valid, the Product purchaser must complete and submit the applicable Product registration card within ninety (90) days of the eligible Product’s first retail sale. This Warranty applies to the original OutBack Product purchaser, and is transferable only if the Product remains installed in the original use location. The warranty does not apply to any Product or Product part that has been modified or damaged by the following:

Installation or Removal;

Alteration or Disassembly;

Normal Wear and Tear;

Accident or Abuse;

Corrosion;

Lightning;

Repair or service provided by an unauthorized repair facility;

Operation contrary to manufacturer product instructions;

Fire, Floods or Acts of God;

Shipping or Transportation;

Incidental or consequential damage caused by other components of the power system;

Any product whose serial number has been altered, defaced or removed; or

Any other event not foreseeable by OutBack.

OutBack’s liability for any defective Product, or any Product part, shall be limited to the repair or replacement of the Product at OutBack’s discretion. OutBack does not warrant or guarantee workmanship performed by any person or firm installing its Products. This Warranty does not cover the costs of installation, removal, shipping (except as described below), or reinstallation of Products.

Revision.2007-08-29

30

Image 31
Contents NetTM DC About OutBack Power Systems WarrantyFLEXnet DC User’s Guide 2007 All rights reserved January DisclaimerDate and Revision Contact InformationTable of Contents Introduction OutBack Power Systems FLEXnet DCSystem Overview Reading the FLEXnet DC Postion wiring blockFLEXNet DC package includes Installing the FLEXnet DCConnect each twisted pair to a shunt Torque Values Wiring Block ConnectionsWhite to BAT Black to BAT + Installing the FLEXnet DC Maximum amp charged Maximum battery voltageFLEXNet DC Measurements KiloWattsLogged Data User Adjustable Set PointsData Logging Programming and Using the Mate for FLEXNet DC Operations Typical charge cycle All unused channels should be set to disabledFLEXNet DC Modes Charge CycleGreen Yellow RED Invert Logic Hi Set Point Satisfied Auto ModeProgramming the Auxiliary Relay Relay LogicMate Screens Readings Press the DC soft key to view the status of the FlexNet DCDown Status STATUS/FN Stats Meter Shunt Batt TOP STATUS/DC/SHUNT a Down UP Reset Down UP Reset TOP STATUS/DC/BATT UP TOP Status ADV BAT Shunt PG2 Press the ADV soft key Press the DC soft key Press the Charge soft keyPG1 Charge AUX PG3 ADV/DC/AUX Control ADV/DC/AUX SOC LOW PG2 Reset CLR Main Technical Notes Battery Charge Factor BCFFLEXnet Products Year Limited WarrantyRevision.2007-08-29 Outback Power Systems Inc 19009 62nd Ave. NE Limited Warranty RegistrationREV B