Outback Power Systems DC manual System Overview

Page 6

SYSTEM OVERVIEW

BAT +

BAT -

C BAT (-)

C DEVICE

B DEVICE

netTM DC

CHARGE CONTROLLER BATTERY -

SHUNT C

CHARGE CONTROLLER

FX BATTERY -

SHUNT B

B BAT (-)

 

A BAT (-)

A DEVICE

 

 

 

FX INVERTER/CHARGER

 

 

 

 

 

 

 

BATTERY -

OTHER DC

 

 

SOURCE OR

 

 

SHUNT A

LOAD

 

Think of the input shunts as breaks or junctions in the DC (-) conductor. The current is conducted as though it were a continuous conductor, but the shunts allow the user to monitor the current, providing information for more accurate battery recharging.

5

Image 6
Contents NetTM DC Warranty About OutBack Power SystemsFLEXnet DC User’s Guide 2007 All rights reserved Contact Information DisclaimerDate and Revision JanuaryTable of Contents OutBack Power Systems FLEXnet DC IntroductionSystem Overview Postion wiring block Reading the FLEXnet DCInstalling the FLEXnet DC FLEXNet DC package includesConnect each twisted pair to a shunt Wiring Block Connections Torque ValuesWhite to BAT Black to BAT + Installing the FLEXnet DC KiloWatts Maximum battery voltageFLEXNet DC Measurements Maximum amp chargedUser Adjustable Set Points Logged DataData Logging Programming and Using the Mate for FLEXNet DC Operations Charge Cycle All unused channels should be set to disabledFLEXNet DC Modes Typical charge cycleGreen Yellow RED Relay Logic Auto ModeProgramming the Auxiliary Relay Invert Logic Hi Set Point SatisfiedMate Screens Press the DC soft key to view the status of the FlexNet DC ReadingsDown Status STATUS/FN Stats Meter Shunt Batt TOP STATUS/DC/SHUNT a Down UP Reset Down UP Reset TOP STATUS/DC/BATT UP TOP Status ADV BAT Shunt PG2 Press the Charge soft key Press the ADV soft key Press the DC soft keyPG1 Charge AUX PG3 ADV/DC/AUX Control ADV/DC/AUX SOC LOW PG2 Reset CLR Main Battery Charge Factor BCF Technical NotesYear Limited Warranty FLEXnet ProductsRevision.2007-08-29 Limited Warranty Registration Outback Power Systems Inc 19009 62nd Ave. NEREV B