Outback Power Systems DC manual Table of Contents

Page 4

TABLE OF CONTENTS

Warranty Summary

1

Introduction

4

System Overview

5

Reading the FLEXnet DC

6

FLEXnet DC Package

7

Installing the FLEXnet DC

7-10

FLEXnet DC Measurements

11

Logged Data

12

User Adjustable Set Points

12

Programming and Using the MATE for FLEXnet Operations

13

FLEXnet DC Modes

14

Programming the Auxiliary Relay

16

MATE Screens

17-28

Technical Notes

29

Warranty

30-31

Warrranty Registration

32

3

Image 4
Contents NetTM DC About OutBack Power Systems WarrantyFLEXnet DC User’s Guide 2007 All rights reserved Disclaimer Date and RevisionContact Information JanuaryTable of Contents OutBack Power Systems FLEXnet DC IntroductionSystem Overview Postion wiring block Reading the FLEXnet DCInstalling the FLEXnet DC FLEXNet DC package includesConnect each twisted pair to a shunt Torque Values Wiring Block ConnectionsWhite to BAT Black to BAT + Installing the FLEXnet DC Maximum battery voltage FLEXNet DC MeasurementsKiloWatts Maximum amp chargedLogged Data User Adjustable Set PointsData Logging Programming and Using the Mate for FLEXNet DC Operations All unused channels should be set to disabled FLEXNet DC ModesCharge Cycle Typical charge cycleGreen Yellow RED Auto Mode Programming the Auxiliary RelayRelay Logic Invert Logic Hi Set Point SatisfiedMate Screens Press the DC soft key to view the status of the FlexNet DC ReadingsDown Status STATUS/FN Stats Meter Shunt Batt TOP STATUS/DC/SHUNT a Down UP Reset Down UP Reset TOP STATUS/DC/BATT UP TOP Status ADV BAT Shunt PG2 Press the Charge soft key Press the ADV soft key Press the DC soft keyPG1 Charge AUX PG3 ADV/DC/AUX Control ADV/DC/AUX SOC LOW PG2 Reset CLR Main Battery Charge Factor BCF Technical NotesYear Limited Warranty FLEXnet ProductsRevision.2007-08-29 Limited Warranty Registration Outback Power Systems Inc 19009 62nd Ave. NEREV B