Reset the settings/Reboot the unit [Default reset]
It is possible to reset the settings or reboot the unit on the [Default reset] tab of the "Maintenance" page on the setup menu.
The settings and the HTML data of the unit can be initialized and reboot of the camera and the unit can be per- formed on this page.
[Reset to the default (Except the network settings)] Click the [Execute] button to reset the settings of the unit and
It is impossible to operate the unit for around 2 minutes after the initialization.
Note:
•The following network settings will not be reset.
On/Off for DHCP, IP address, subnet mask, default gateway, HTTP port, line speed, bandwidth control (bit rate), time & date
[Load the default HTML files (setup menu).]
Click the [Execute] button to reset the settings of the unit,
[Reset to the default and load the default HTML files.]
Click the [Execute] button to reset the settings of the unit,
Note:
•The following network settings will not be reset.
On/Off for DHCP, IP address, subnet mask, default gateway, HTTP port, line speed, bandwidth control (bit rate), time & date
[Camera restart]
Click the [Execute] button to restart all the cameras connected to the unit. After restart, it is impossible to control the camera around 1 minute.
[Unit restart]
Click the [Execute] button to reboot the unit.
The unit will be inoperable for around 2 minutes after the restart just as when the power is turned on.
Note:
•To initialize the network settings (☞ page 54), turn off the power of the unit, then turn on the power again while holding down the [INITIAL SET] button on the unit for 5 seconds. Wait around 2 minutes after releasing the button. The unit will start up and the settings including the network settings will be initialized.
Do not turn off the power of the unit until the initial- ization is complete and the SDHC/SD memory card error LED lights up.
•The notification function allows users to provide the notification of the error to the specified mail address and an original alarm destination when an error such as no SD memory card insertion after the reboot or a locked SD memory card insertion occurs. (☞ Page 48)
23