Panasonic WJ-GXE500E manual Image/Position tab, Setup items

*12 • When "Frame rate" is set for "Transmission priority", number of users who can access the unit may be decreased.

*13 • When "Frame rate" is selected for "Transmission priority", this setting is available.

*14 • "Frame rate" is synchronized with "Max bit rate (per client) *". For this reason, the frame rate may be lower than the specified value when any value marked with an asterisk (*) is selected.

*15 • "Unlimited *" is available when "Frame rate" is selected for "Transmission priority".

*16 • The bit rate is synchronized with "Bandwidth control(bit rate)" on the [Network] tab of "Network" page. For this reason, the bit rate may be lower than the value when any value with an asterisk (*) on the right is selected.

*17 • When "Unlimited *" is selected for either "MPEG-4(1)" or "MPEG-4(2)", the maximum concurrent access number is 1 user.

*18 • When "Constant bit rate" is selected for "Transmission priority", this setting is available.

*19 • Depending on the setting or photographic subject, images may not be refreshed at the exact designated interval.

*20 • When "Multicast" is selected, set the value of "Bandwidth control(bit rate)" on the [Network] tab of "Network" page greater than the total value of "Max bit rate (per client) *" of all the channels in use.

*21 • The following port numbers are unavailable since they are already in use. 10 669, 10 670

*22 • When audio is transmitted from the unit, the port number to be used will be the multicast port number plus "1 000".

*25 • When "On" is selected for "MPEG-4 transmission" of "MPEG-4(1)", the setting values selected for "MPEG-4(1)" will be applied.

[Image/Position] tab

Refer to page 28 for general information about this tab.

Setup items

Ch No.

Menu

Operation buttons

Zoom

Focus

Control pad

Setting values (Underlined: default):

1/2/3/4

On/Off

Set

Up

Down

Left

Right

Esc

Reset/Special

All Reset

Zoom out/x1/Zoom in

Auto/Near/Far

40