Panasonic KX-FPG378 Pressing Redial Will not be redialed correctly, Fully charge the battery

Page 87

 

10. Help

 

 

Problem

Cause & Solution

Static, sound cuts in/out,

L Move the handset and the base unit away from other electrical

fades. Interference from

appliances.

other electrical units.

L Move closer to the base unit.

 

L Raise the base unit antenna.

 

 

While programming, the

L To answer a call, press {TALK} or {SP-PHONE}. Start again from

handset starts to ring.

the beginning after hanging up.

 

 

I cannot redial by

L If the last number dialed was more than 48 digits long, the number

pressing {REDIAL}.

will not be redialed correctly.

 

 

Recharge battery” is

L Fully charge the battery (page 20).

displayed, 68879 flashes

 

or the handset beeps

 

intermittently.

 

 

 

Charge for 6h” and

L The battery has been discharged. Fully charge the battery (page

68889 are displayed and

20).

the handset does not

 

work.

 

 

 

I charged the battery fully,

L Clean the charge contacts and charge again (page 20).

but “Recharge battery

L The battery may need to be replaced (page 17). If you install a new

is still displayed and/or

battery, fully charge it (page 20).

68879 continues to flash,

 

or “Charge for 6h” and

 

68889 are displayed.

 

The [CHARGE] indicator

L This is normal.

does not go out after the

 

battery has been charged.

 

 

 

I cannot receive

L You must set remote fax activation to ON (feature #41 on page 72)

documents by pressing

beforehand.

{*}{#}{9} on the

L Press {*}{#}{9} firmly.

handset.

L The memory is full of received documents due to a lack of

 

recording paper or a recording paper jam. Install paper or clear the

 

jammed paper.

 

 

The handset display is

L Fully charge the battery (page 20).

blank.

 

 

 

I cannot have a

L Make sure that an optional headset is connected properly (page

conversation using the

18).

headset.

L If SP-phoneis displayed on the handset, press {TALK} to

 

switch to the headset.

I cannot program items.

L Programming is not possible while the handset and/or base unit is

 

being used.

 

L Do not pause for over 1 minute while programming.

 

L Move closer to the base unit.

 

L While another user is listening to messages or the telephone

 

answering machine is answering a call, you cannot program. Try

 

again later.

 

 

For Fax Advantage assistance, call 1-800-435-7329.

85

Image 87
Contents GHz Cordless Phone System with FAX and Copier KX-FPG378 KX-FPG379Open How to use the operating instructionsFLASH/CALL Wait I HOLD/INTERCOM E Menu H Navigator F Location of controlsButtons Listed in alphabetical order ButtonsTrademarks Thank you for purchasing a Panasonic fax machineFor your future reference Energy StarWet locations Never touch uninsulated telephone wires or Important safety instructionsInstallation Never install telephone wiring during a lightning stormFor Fax Advantage assistance, call For best performance Distinctive Ring service from your Making a phone call using the phoneViewing and calling back using caller Sending a fax using the phone book100 102103 Included accessories Quick installation guidePart number*1 Quantity Description of base unit buttons Accessory informationDescription of handset buttons Handset displayed items Displayed item Meaning Battery strengthRedial To redial one of the last 5 numbers dialed from the handsetOverview Base unitHandset Installing the ink film Ink filmIncluded film roll is a starter ink film Correct Turn TightIncorrect Paper tray Replacing the ink filmTo use A4 size paper Recording paper Push the tension plate backCorrectIncorrect Battery replacement Battery installationTo attach the belt clip To remove the belt clip To switch to the speakerphone while using the headsetBelt clip Headset optionalConnections Using surge protectorsBattery charge Stop SET Menu Quick Setup Press SETPrint SETUP? YESSET/NOSTOP Selecting the way to use your fax machineYour situation How to setupSelect a Setup Case 1 TAM/FAX Telephone Answering Machine/FaxSelect a Setup =DIST. Ring ± How to receive phone calls and faxes Case 3 TEL onlyFAX/START Menu SP-PHONESET Stop Talk SP-PHONE Preparation Case 4 FAX only How faxes are received=FAX only Intercom Adjusting handset volumeBase unit help function TalkAdjusting base unit volume Date and time Stop Menu Your logoExample +234 Your fax numberSET Menu FLASH/CALL Wait Your FAX no Press SETHold Redial Making phone callsWith the handset Menu SP-PHONEMIC SP-PHONE Mute REDIAL/PAUSE With the base unitSP-PHONE OFF Any key talk featureAuto talk feature Handset Answering phone callsTo delete a character/number You can also send faxes using the phone book StopStoring names and telephone numbers into the phone book Make sure the handset and base unit are not being usedMake sure the handset is not being used Making a phone call using the phone bookTalk or SP-PHONE Chain dial feature Helpful hintsEditing a stored item Press Press a or B repeatedly to display the desired itemTo dial the displayed number, press SP- Phone Copying all the phone book items Erasing a stored itemCopying phone book items from the base unit to the handset Copying one phone bookCaller ID service How Caller ID is displayedTo print manually, see Viewing and calling back using caller information Call Waiting Caller ID featureFLASH/CALL Wait again FAX/START SP-PHONE With the handset Make sure the handset is not being used Caller ID number auto edit featureTurning on the Caller ID number auto edit feature To edit a telephone number before calling back/storingPress SET Press Stop Erasing caller informationErasing all caller information Erasing specific caller informationInto the base unit This feature is not available in the following casesStoring caller information into the phone book Into the handsetTransferring a call IntercomDuring a transfer Handset Press TALK, SP-PHONEorHOLD/INTERCOM to answer To complete the transfer, press SP- PhoneSending a fax manually Documents you can send Adding a new item into the broadcast memory Sending a fax using the phone bookBroadcast transmission Programming items into the broadcast memoryTo send the same document to a one-time group of items To cancel broadcast transmissionErasing a stored item from the broadcast memory Sending the same document to pre-programmed partiesReceiving a fax manually Auto answer Activating TEL modeHow to receive phone calls and faxes with the base unit How to receive calls and faxes with the handsetHow to receive faxes with an extension telephone TAM/FAX Mode 2 RingsReceiving a fax automatically Auto answer on Receiving a voice message and fax document in one call Activating FAX only modeChanging the ring setting in TAM/FAX mode How phone calls and faxes are receivedTo print the junk fax prohibitor list Activating the junk fax prohibitorStoring undesired callers To display the junk fax prohibitor listDistinctive Ring service from your phone company Using two or more phone numbers on a single telephone lineActivating the Distinctive Ring feature Programming the ring pattern assigned for fax Ring pattern SettingsMaking a copy More copying featuresExample Making 2 copies of a 4-page original document Letter LegalLetter = 216 mm ⋅ 279 mm 81/2 ⋅ To collate multiple copiesUnit will play the greeting message Recording your greeting messageErasing your recorded greeting message To check the greeting messageTo play back messages Listening to recorded messages using the base unitSP-PHONE Menu Erasing recorded messagesTo erase a specific message To erase all messagesTo playback all messages To turn OFF the Auto Answer modeTo turn on the Auto Answer mode Leaving a message for others or yourselfSummary of remote operation Operating from a remote locationRemote operation using remote commands How this feature works Transferring recorded messages to another telephoneRecording your transfer greeting message Your pager will display the caller’s telephone number SET Direct command chart for base unitFor more details on the features, see page 69 to MIN defaultSet default YES 2 no default Greeting time 16s default 2 60s Copy phone book Item defaultBasic features Advanced features #36 Receiving oversized documents #26 Setting the Caller ID list to print automatically#31 Activating the Distinctive Ring feature #34 Setting the quick scan#46 Setting friendly reception #42 Setting the message alert#43 Setting the recording time alert #44 Setting the memory reception alert#76 Setting the connecting tone #67 Setting the incoming message monitor#72 Setting flash time #75 Setting the Caller ID number auto edit featureHandset programming Direct command chart for handsetFor more details on the features, see page 76 to Set line mode 053 2 B defaultRecording time 062 3min defaultRemote code 063 Display language English default Message alert On 0 Off defaultProgramming features Changing the maximum recording time for incoming messages Changing the ring setting TAM/FAX modeSetting remote operation code # Setting the message alertRe-registering the handset Error messages Display Error messages ReportsFAX in Memory ErrorModem Error Cover Open Check FilmPlease Wait Serial ErrorTransmit Error Phone Book FullSystemisbusy When a function does not work, check here Initial settingsGeneral Cordless handset Pressing Redial Will not be redialed correctly Fully charge the batteryBattery has been discharged. Fully charge the battery Clean the charge contacts and charge againFax receiving Fax sendingCopying If a power failure occurs Answering machineCaller information will not be displayed if a message is When the recording paper has jammed in the unit Recording paper jamsDisplay will show the following Correct When the recording paper was not fed into the unit properly Document jams sendingStart Do not use paper products, such as paper towels or tissues Document feeder/scanner glass cleaningThermal head cleaning Help Reference lists and reports Base unit only Technical data about this product Frequency Recording paper specifications Recording paper sizeRecording paper weight Mass Weight Approx g 0.42 Ib Power supplyFCC and Other Information FCC RF Exposure Warning Laser Facsimile Limited WarrantyFAX categories Parts Labor Thermal Transfer Facsimile101 Customer Services Directory Customer Services directory#77 Auto Answer Index104 105 106 107 PFQX2138ZA CM1204DH0 PFQX2138ZA CM1204DH0 Panasonic FAX Advantage Program