Panasonic KX-FLB811 manual Copying, Using an answering machine

Page 75

 

 

 

 

9. Help

 

 

 

 

 

Problem

Cause & Solution

 

When an extension

L You must set remote fax activation to ON (feature #434 on page 63)

telephone is connected, I

beforehand.

 

cannot receive

L Press {*}{#}{9} firmly.

 

documents by pressing

L You may have changed the remote fax activation code from

{*}{#}{9}.

{*}{#}{9} (default setting). Verify the remote fax activation code

 

(feature #434 on page 63).

 

 

L The memory is full of received documents due to a lack of

 

recording paper or a recording paper jam. Install paper (page 18)

 

or clear the jammed paper (page 79).

 

 

L If feature #442 is set to ALWAYS(page 64), check the connection

 

between the computer and the unit.

 

9.3.5 Copying

 

 

 

 

 

 

 

 

 

Problem

Cause & Solution

 

The unit will not make a

L You cannot make a copy during programming. Make the copy after

copy.

programming.

 

 

L The document was not fed into the unit properly. Re-insert the

 

document.

 

 

L Recording paper is not installed or the unit has run out of paper.

 

Install paper (page 18).

 

 

L Recording paper is installed in the manual input tray. Remove the

 

recording paper from the manual input tray.

 

 

 

 

 

A black line, a white line or

L The glass or rollers are dirty with correction fluid, etc. Clean them

smudge appears on the

(page 84, 87). Please do not insert a document before correction

copied document.

fluid has dried completely.

 

 

 

 

 

 

The printing quality is

 

Original

Copy

poor.

 

 

 

 

 

 

ABC

 

 

 

 

 

 

 

LSome paper has instructions recommending which side to print on. Try turning the paper over.

LYou may have used paper with a cotton and/or fiber content that is over 20%, such as letterhead or resume paper.

LThe remaining toner is low. Replace the toner cartridge (page 76). L To check the drum life and quality, please print the printer test list (page 89). If printing quality is still poor, replace the toner cartridge

and drum unit.

L The toner save mode of feature #482 is ON (page 60).

9.3.6Using an answering machine

Problem

Cause & Solution

I cannot receive

L Your greeting message on the answering machine is too long.

documents automatically.

Shorten the message. Record a message up to 10 seconds long.

 

L The answering machine rings too many times. Set to 1 or 2 rings.

 

 

I cannot receive voice

L Check if the answering machine is turned ON and connected to the

messages.

unit properly (page 37).

 

L Set the number of rings on the answering machine to 1 or 2.

 

 

For assistance, please visit http://www.panasonic.com/consumersupport

73

Image 75
Contents Operating Instructions Open How to use the operating instructionsLocation of controls Directory EStop K Copyright Thank you for purchasing a Panasonic fax machineEnergy Star TrademarksInstallation Important safety instructionsToner cartridge Laser radiationFuser unit KX-FLB811 KX-FLB801Static electricity For best performanceToner cartridge and drum unit Damage to the unit Poor print quality Improper OperationMoving the unit Unit should not be exposed to direct sunlightRecording paper Routine careUsing two or more phone numbers on a Selecting the operation mode FaxUsing the unit with an answering Distinctive Ring service from yourDocument jams Auto document Cleaning the white plateCleaning the document feeder Replacing the toner cartridgePart number*1 Quantity Included accessoriesDescription of buttons Accessory informationFront view OverviewE F G H Rear viewToner cartridge and drum unit Close the manual input tray 3 before opening the top cover For KX-FLB811 users Toner save featureDocument tray Output trayIf the top part of the extender is detached For KX-FLB801 usersKX-FLB801 If the extender is detached KX-FLB811Recording paper Using the paper input trayApprox kg 4.4 lb Using the manual input trayPaper in Tray #2 For PC Printing Using the optional handset unit Using surge protectorsConnections Dialing Mode Dialing modeSelecting the operation mode Fax/Copy/Scan System SetupHelp function Adjusting volumeExample 1015PM 12 hour clock entry 1. Press 10 If you have subscribed to a Caller ID serviceDate and time Example August 10, 2006 Press 08 10Quick Scan Stop Your logoZOOM/QUICK Scan Menu SET Flash ZoomTo insert a character To select characters using V orTo delete a character To erase all characters, press and holdTo delete a number Your fax numberMenu Stop SET Flash Your FAX no Press SETSending a fax manually Using the unit as a fax machineEntering the fax mode Using the auto document feederFAX SET Stop Quick Scan Start Using the scanner glassStandard Document weightExample PAGES=01For stations Dial ModeStoring one-touch dial item Directory Menu StopTo delete a character/number Storing navigator directory itemsEditing a stored item Erasing a stored itemIf your unit does not send a fax Using stationsUsing navigator directory Fax auto redialErasing a stored item from the broadcast memory Broadcast transmissionProgramming items into the broadcast memory Adding a new item into the broadcast memorySending the same document to pre-programmed parties To cancel broadcast transmissionReceiving a fax manually Auto answer Activating FAX only modeActivating TEL mode Receiving a fax automatically Auto answer onTo stop receiving Using the unit with an answering machineSetting up the unit and an answering machine How to receive faxes with the optional handset unitReceiving a voice message and fax document in one call Fax activation code feature #434 onActivating the junk fax prohibitor Storing undesired callersTo display the junk fax prohibitor list To print the junk fax prohibitor listTo erase an item from the junk fax prohibitor list Menu Stop Caller ID Caller ID serviceViewing and calling back using caller information How Caller ID is displayedErasing specific caller information Into the one-touch dial feature and navigator directoryStoring caller information Erasing all caller informationRing pattern Settings Distinctive Ring service from your phone companyUsing two or more phone numbers on a single telephone line Activating the Distinctive Ring featureOther triple ring short Short-long rings 1st ring 2nd ring Programming the ring pattern assigned for faxCopy Stop Using the unit as a copy machineEntering the copy mode Making a copyCopy Stop Start You can change the default resolution in feature #461To stop copying Text For documents containing only textOriginal document More copying featuresUsing the scanner glass To enlarge a documentCollated pages Uncollated pages Example Making 2 copies of a 4-page original documentRAM Connecting to a computerInstalling Multi- Function Station CPUTo modify the software Insert the included CD-ROM into your CD- ROM driveImportant notice for Windows XP users To use the other unit with the computerUsing the unit as a printer Starting Multi-Function StationPrinting from Windows applications Labels TransparenciesEnvelopes Remove each envelope after printingPeel-off strip Multiple flaps Using the unit as a scanner Using Multi-Function ViewerSelect ViewerScan Multi-Function Viewer will appear Readiris OCR software Using other applicationsOperating the unit from your computer To scan documents quicklySelect Pcfax Panasonic KX FLB811/PCFAX Panasonic KX-FLB801 Fax sending/receiving using Multi-Function StationReceiving a fax into your computer Changing the default output trayConfirming the status of the unit Other information KX- FLB811 onlyOutput tab Programming To cancel programmingTo select features by using the navigator key Basic Feature FAX Feature Copy FeatureBasic features Correct settingNormal default For normal contrast OFF default Deactivates this feature Fax features On default You will hear connecting tones To cancel after programming, press Stop then SETYou can also send a document using the scanner glass. Press Setting the ErrorDefault code is #9 Feature/Code SelectionOn default Enter your code from 2 to 4 digits, using 0-9, * and #Connection Feature/Code Selection Receiving a fax intoRecognize the connection, it will store a received document Memory once, then transfer the data after recognitionCopy features To change the default resolution setting for copyingResolution Error messages Reports Display Cause & Solution Error messages DisplayRecording paper is installed in the manual input tray when Service personnelPaper. Install paper page 18 Cable or the computer power cord is not connected correctlySize paper. Use the appropriate size paper Wrong PaperWhen a function does not work, check here Initial settingsGeneral Fax receiving Fax sendingDocuments automatically Pressing FAX Auto Answer Receiving modeAuto Answer indicator Paper is installedCopying Using an answering machineMulti-Function Station If a power failure occurs Toner LOW Toner Empty Replacing the toner cartridge and the drum unitRemove the drum and toner unit 1 by holding the tabs Close the top cover until locked Display will show the following When the recording paper has jammed inside of the unitRecording paper jam Waste disposal methodCase Remove the jammed paperPull and hold the lever 1 to release the jammed paper When the recording paper is not fed into the unit properly Check Pick UP Input Tray #1Check Pick UP Input Tray #2 Remove the jammed document 1 carefully When the document has jammed near the document exitWhen the document has jammed near the document entrance Document jams Auto document feederCleaning the white plate and glasses Disconnect the power cord Open the document coverWhite plate and scanner glasses If the document cover comes off from the unit Close the document cover Re-connect the power cordLower glass Cleaning the document feeder rollers Help Reference lists and reports Specifications % image area Recording paper weightEnvelope size Toner lifeDrum life FCC and Other Information Responsible Party Laser Facsimile Limited WarrantyFAX categories Parts Labor Thermal Transfer FacsimileFor In Limited Warranty product service Customer Services Directory Customer Services directoryUser record For your future referenceAttach your sales receipt here Index Activating Installing Navigator directory Sending faxes100 101 102 103 Panasonic FAX Advantage Program No Extra Cost