Power Module Turn-On State
When you turn on the mainframe, the power module goes through a
Note | The figure assumes the power module still retains its factory default |
| state if desired (see "Chapter 4 - Basic Power Module Commands"). |
|
|
Checking Basic Module Functions
The power module is designed for remote programming over the GPIB. It also can be locally programmed from the optional Agilent 66001A MPS Keyboard. Table
Command
Table
Action |
|
| Display Response | |||||
| VOLTS | AMPS |
| CV | CC | Addr* | Dis | Prot |
Output Voltage (Disconnect Load)
VOLT 5.1 | Set output voltage to 5.1 V |
OUTP ON | Enable the output |
Overvoltage Protection | |
VOLT:PROT 4.9 | Activate OVP circuit (by |
| setting protection voltage |
| below output voltage) |
VOLT:PROT MAX | Clear OVP circuit |
OUTP:PROT:CLE | Clear OVP circuit |
Save and Recall Functions | |
*SAV 5 | Save present state to |
| location 5 |
VOLT 3.55 | Set output voltage to 3.55 V |
OUTP OFF | Turn off the output |
*SAV 6 | Save present state to |
| location 6 |
*RCL 5 | Restore state 5 |
*RCL 6 | Restore state 6 |
Output Current (With output disabled, short the output terminals with a wire size sufficient to carry the maximum current of the module.)
0.00
5.10
0.00
5.10
5.10
5.10
3.55
0.00
0.00
5.10
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
Off
On
Off
Off On
On
On
Off
Off
On Off
Off
Off
Off
Off Off
Off
Off
Off
Off
Off Off
On
On
On
On On
On
On
On
On
On On
On
Off
Off
Off Off
Off
Off
On
On
Off On
Off
Off
On
Off Off
Off
Off
Off
Off
Off Off
CURR 3.1 | Set output current to 3.1 |
| amps |
OUTP ON | Enable the output |
Overcurrent Protection | |
CURR:PROT:STAT | Activate OCP circuit (by |
ON | enabling OCP when the |
| output is shorted) |
| Clear OCP circuit |
|
|
0.00
0.00
0.00
0.00
0.00
3.10
0.00
0.00
Off
Off
Off
Off
Off
On
Off
On
On
On
On
On
On
Off
Off
On
Off
Off
On
Off
Clear OCP circuit | 0.00 | 3.10 | Off | On |
*Addr will not light if the module is controlled from the keyboard.
On
Off
Off
28