Avery 206 Electronics, Internal Interfaces, Status messages, test functions, product profiles

CONTENTS

2.1OVERVIEW

Electronics

Processor:	32 Bit CPU MIPS Core
RAM:	16 MB
ROM:	4 MB
Control panel:	graphical display with
	128 x 32 pixels, 2/4 lines,
	5 buttons

Interfaces

Sensor interfaces for	(plug in each case 4-
external sensors	pin M12)
Label sensor:	Wenglor OPT242-P800
	optical, NPN, 24 V, con-
	trollable sensitivity
Alternative label	PNP/NPN, 24 V
sensor:
Product sensor:	PNP/NPN, 24 V
APSF-sensor (Rotary	single-phase/two-phase,
encoder):	PNP/P-P, 24 V, max.
	20 kHz
Stock sensor:	PNP, 24 V
Internal sensor interfac-
es:
Material unwinder	Light barrier
Pressure roller	not used
Dancer arm	bi-phase light barrier en-
	coder
PLC interface	Sub D15, optically insu-
	lated, optionally via two
	8-pin M12 (separate in-
	puts/outputs in each
	case)
Outputs:	4x PNP, 24 V, a maxi-
	mum of 500 mA/channel,
	total permissible output
	current: 1500 mA
Inputs:	3x PNP/NPN, 24 V

ALS 20x 256

GB

Data interfaces:
Serial:	RS232C (Sub-D9),
	max. 115 200 Baud
Ethernet:	10/100 BaseT (RJ45)
USB:	Device V1.1 (USB B),
	‘Full speed’ operating
	mode, 12 MBit/s
CF card:	Slot for 1 CompactFlash
	card
Control panel	RS 485 (Mini DIN 6 con-
interface:	nection) for remote con-
	trol

Internal Interfaces

RFID	Connection for RFID
	read/write unit (special
	equipement) 6)
Applicator Interface	Connection for Applicator
	Interface (AI) board (spe-
	cial equipement)
Connector for additional	not used
motor driver
6) Not yet available

Status messages, test functions, product profiles

Automatic halt, if	... the label roll is spent or
	no gap was found.
	...the max. admissible
	number of missing labels
	is reached.
Test functions:	Automatic diagnostics
	check when switched on
	Output of system data via
	data interface
Status indicators:	Label counter
	Operating hours counter
Storage locations for	up to 16
product profiles:

15