CONTENTS
4.2CONFIGURATION AND MONITORING
4.2.2Monitoring functions
ALS 20x 256
GB
While in dispensing mode, an electronic controller monitors the following functions:
Material tear
If the material path tears, one of these two messages appears:
Missing labels
A label missing from the label roll does not normally affect the dispensing operation, because the label feed continues until a label’s edge passes under the label sensor.
Nonetheless, it can be important that missing labels are reported. By configuring the function LABEL SETUP > Miss. label tol., you can specify whether an error message is triggered after one or several missing labels.
Status num: | 5002 |
Material end |
|
|
|
|
|
Status num: | 5140 |
Rewinder control |
|
|
|
–Which message appears depends on where the material path is torn.
–The machine stops.
Press the 
button.
Material end
The following message appears when the material roll is empty:
Status num: | 5002 |
Material end |
|
|
|
–The machine stops.
Press the button 
to delete the message. Remove the rewound backing paper.
Insert a new material roll (see “Inserting label material” on page 32).
44