Avery 256, 204, 206 manual Set to Dhcp Interface Para

CONTENTS

6.1ERROR MESSAGES

ALS 20x 256

GB

Status Status text Cause Action to take

5147 Tandemsynch. Init	This message can only appear
	during tandem operation.

–Communication between the master and slave machines is not function- ing.

Check tandem interface cable.

–Is it a) in place and b) correctly con- nected?

Check the settings on both ma- chines.

–Siehe “Setting up tandem operation” auf Seite 112.

5200	Home position		This message may appear when
			operating the applicator. The ap-
			plicator did not reach its home
			position (upper end position)	Remove any obstructions
			within the intended time-frame.
		– The applicator is stuck		Check compressed air connection
				and reconnect correctly if necessary
		– Compressed air applicator: Com-
				Check cable and connect correctly if
		pressed air supply interrupted or
				necessary.
		switched off
		– Cable not correctly connected.
5201	Touch Down	The applicator lower end position
		(Touch Down) was not reached in time.
6002	New prog. vers.	New firmware has been loaded. This is a		Press the Online button to confirm.
		message from the labeller that new		– All parameters are reset to their fac-
		firmware is available.		tory settings.
6031	New Parameters	New firmware was loaded with the result		No action necessary. The message
		that new functions have been added to
				is for information only.
		the menu.
6207	No file card	No compact flash card was found.		Check whether a compact flash card
				is connected. If the compact flash
				card was not connected until after the

machine was switched on: Switch the machine off and back on again.

9022 No network link	This status message can only appear
	when Ethernet address assignment is
	set to DHCP (INTERFACE PARA >
	NETWORK PARAM.> IP Addressassign). The
	cause is almost invariably an incorrectly
	plugged-in network connector.

Check whether the network connec- tor is plugged in correctly, correct if necessary.

[53] List of error messages

52