B&K 1788, 1786B, 1785B, 1787B instruction manual Front Panel at a Glance

Page 5

The Front Panel at a Glance

?10 digits VFD display

?Status information for operating mode and working status

?Power switch

?Number keys

?Function keys

?UP/DOWN and ENTER key

?Output terminals

Image 5

Contents Page Content Quick Reference About your safetyGeneral information Protection from electric shockCertification Certification and WarrantyIntroduction Front Panel at a Glance Display annunciators Function keys descriptionMenu description Cal Rear Panel at a GlanceQuick Start Connect the power cord and turn on the power supplyPreliminary Checkout Check the list of supplied itemsCurrent Output Checkout Output CheckoutVoltage Output Checkout To Adjust the Carrying Handle If the Power Supply Does Not Turn OnVerify that there is AC power to the power supply Verify the power-line voltage settingBench-top viewing positions Carrying position To Rack Mount the InstrumentSpecifications SpecificationsMaximum input power Supplemental CharacteristicsEnvironmental Conditions Unit mmConstant Voltage Operation Front-panel OperationFront-panel Operation Overview Saving and Recalling Operation Constant Current OperationMenu Operation Set Maximum voltageMAX VoltSetting the Baud RateBAUDRATE Setting the Key SoundKEY SoundInitiating the Output stateINIT OUT Initiating the Output Voltage Init VoltSetting password for function keysKEY Lock Setting Address AddressIT-E131 Communication cable Remote Operation ModeCommunication setting Frame format Setting the remote control mode 20HCommunication protocol DescriptionSetting the output voltage 23H Setting the output state ON/OFF 21HSetting the maximum output voltage 22H Setting the communication address 25H Setting the output current 24HReading the calibration state 28H Entering the calibration mode 27HCalibrate the current value 2BH Calibrating the voltage value 29HReading calibration information 2FH Setting calibration information 2EHSave the calibration data to Eeprom 2DH Return information of command operation in power supply 12H Restore the factory default calibration data 32HEnable the local key 37H Calibration Voltage calibration ConfigurationCurrent calibration Finish calibratingPV1785B1788 Software Reset to the default calibration settingsInstallation Functions of PV1785B1788 Status bar 1Configure the systemQuickly setting Setting Voltage and current4. GO/NG Test Function Program settingSave and Open Present Voltage/Current ChartChart Description Page Limited One-Year Warranty Service Information USA