B&K 1785B, 1786B, 1788, 1787B Function keys description, Menu description, Display annunciators

Page 6

Function keys description

V-set

Set the output voltage value

I-set	Set the current value

Save the present settings to a specified register location(1~16)

Save

Recall a saved settings from location ‘‘1’’through ‘‘16’

Recall

Menu function to set related parameters of the power supply

Output ON/OFF, to enable/disable the output

Out on/off

Menu description

Menu

	>MAX VOLT	Set the maximum output voltage value
	>INIT OUT	Initiate the output state to ON or not
	>INIT VOL	Initiate the output voltage to 0 volt or not
	>KEY SOUN	Switch On/Off the buzzer sound when you press
		any key
	>BAUDRATE	Set the communication baud rate
	>ADDRESS	Set the communication address
	>KEY LOCK	Set the password for function keys
	>EXIT	Exit

Display annunciators

Image 6

Contents Page Content General information About your safetyQuick Reference Protection from electric shockCertification and Warranty IntroductionCertification Front Panel at a Glance Function keys description Menu descriptionDisplay annunciators Rear Panel at a Glance CalPreliminary Checkout Connect the power cord and turn on the power supplyQuick Start Check the list of supplied itemsOutput Checkout Voltage Output CheckoutCurrent Output Checkout Verify that there is AC power to the power supply If the Power Supply Does Not Turn OnTo Adjust the Carrying Handle Verify the power-line voltage settingTo Rack Mount the Instrument Bench-top viewing positions Carrying positionSpecifications SpecificationsSupplemental Characteristics Maximum input powerUnit mm Environmental ConditionsFront-panel Operation Front-panel Operation OverviewConstant Voltage Operation Menu Operation Constant Current OperationSaving and Recalling Operation Set Maximum voltageMAX VoltInitiating the Output stateINIT OUT Setting the Key SoundKEY SoundSetting the Baud RateBAUDRATE Initiating the Output Voltage Init VoltSetting Address Address Setting password for function keysKEY LockRemote Operation Mode Communication settingIT-E131 Communication cable Communication protocol Setting the remote control mode 20HFrame format DescriptionSetting the output state ON/OFF 21H Setting the maximum output voltage 22HSetting the output voltage 23H Setting the output current 24H Setting the communication address 25HEntering the calibration mode 27H Reading the calibration state 28HCalibrating the voltage value 29H Calibrate the current value 2BHSetting calibration information 2EH Save the calibration data to Eeprom 2DHReading calibration information 2FH Restore the factory default calibration data 32H Enable the local key 37HReturn information of command operation in power supply 12H Calibration Current calibration ConfigurationVoltage calibration Finish calibratingReset to the default calibration settings InstallationPV1785B1788 Software Functions of PV1785B1788 1Configure the system Status barSetting Voltage and current Quickly settingProgram setting 4. GO/NG Test FunctionPresent Voltage/Current Chart Chart DescriptionSave and Open Page Limited One-Year Warranty Service Information USA