6 Manual Handling Procedure
6.1 General
6.1.1Items within the
6.1.2The Manual Handling of Loads Regulations, 1993 require that all persons working on the equipment are familiar with the Regulations, that they take care to minimise risk of injury to themselves and others, that they are properly trained, and that the correct equipment is used. Safety shoes are to be worn.
6.1.3If in doubt about methods, ability to handle the loads, training or equipment, do not proceed without first seeking advice from a competent person.
6.2 Preparation
6.2.1Before commencing work check the following:
The floor is level, clean, firm and dry.
The working area is clear of obstacles that could obstruct movement or cause tripping. There is adequate room for the operator(s), equipment and load.
The lighting is sufficient for the load, equipment, loading surfaces, potential hazards and working environment to be seen clearly.
Sound levels are not too high to cause distraction.
6.3 Method
6.3.1The following is not intended to replace other documents and training courses, only to serve as a guide and checklist. For full guidance refer to the Regulations and supporting documents.
6.3.2Before lifting, stand as close as possible to the load.
6.3.3Keep the back straight and as vertical as possible.
6.3.4Use the leg muscles in preference to the arms.
6.3.5Minimise twisting, stretching and stooping.
User Manual | Page 42 of 44 | 18th FEB 02 |
DC MX06 40A Shelf |