Agilent Technologies AGILENT MODELS 6023A and 6028A service manual Model 6023A, Model 6028A, 107

B

Backdating

Manual backdating describes changes that must be made to this manual for power supplies whose serial numbers are lower than those listed in the title page to this manual.

Look in the following table and located your Agilent Model. Then look at each serial number listed for this group. If the serial number of your power supply is prior to any of the serial number(s) listed, perform the change indicated in the Change column. Note that several changes can apply to your supply. You may also be instructed to update your power supply if certain components are being replaced during repair.

Model 6023A		Change
Serial Numbers
PREFIX	NUMBER
3332A	01839-02233	1
3302A	01789-01838	1,2
3215A	01709-01788	1-3
3047A	01559-01708	1-3
2845A	01069-01558	1-4
2704A	00619-01068	1-5
2541A	00364-00618	1-6
2508A	00184-00363	1-7
2428A	00139-00183	1-8
2420A	00124-00136	1-9
2407A	00101-00123	1-10

Model 6028A		Change
Serial Numbers
PREFIX	NUMBER
3544A	00101-00165	1

CHANGE 1

All	In the parts list for the A4 Power Mesh Board change Q3, Q4 to PFET p/n 1855-0547. Under A4
	Power Mesh Board Mechanical change heatsink (Q3, Q4) to p/n 1205-0256. Add hex head
	standoff (Q3, Q4) p/n 0380-1679.
CHANGE 2
6023A	In the parts list for the A1	Main Board Assembly change CR1, 3 to p/n 1901-1087. Change
	CR2, CR4 to p/n 1901-0759.
CHANGE 3
6023A	In the parts list for the A1	Main Board Assembly change C13, C14 to 0.022∝F 10% 1500V p/n
	0160-5933.
CHANGE 4
6023A	In the parts list for the A1	Main Board Assembly change T3 bias transformer to p/n 5080-1982.
	Delete screw p/n 0515-0964, lock washer p/n 2190-0586 and flat washer p/n 3050-0893.

CHANGE 5

107