Epson TM-FX2180 manual $-867017, Disassembling the Right Frame Assembly

EPSON FX-2180 Service ManualChapter 4 Disassembly and Assembly

4.2.11.6 Disassembling the Right Frame Assembly

1. Remove the printer cover, front and rear edge guide assemblies, front cover, paper eject assembly, and front and rear tractor units. (See section 4.2.1.)

2. Remove the panel board assembly. (See section 4.2.2.)

3. Remove the upper housing assembly. (See section 4.2.7.)

4. Remove the printer mechanism. (See section 4.2.11.)

5. Remove the PF motor assembly. (See section 4.2.11.2.)

6. Remove the right sub frame assembly. (See section 4.2.11.4.)

7. Remove the right frame assembly. (See section 4.2.11.5.)

C B S s c r e w s ( 3 x 68. )Remove the following 11 parts from the right frame assembly:

Figure 4-26. Removing the Right Frame Assembly

IMPORTANT
	TThe tightening torque for the hexagonal nut is
$'-8670(17	1.18 - 1.37 Nm (12 - 14 Kgf-cm).
	Adjust the platen gap/parallelism and
	bidirectional print alignment, and reset the TPE
	level. (See Chapter 5.)

2 compression springs (200 g)		2 plain washers
2 spur gears (34.5 mm)		1 spur gear (34 mm)
1 spur gear (27 mm)		1 spur gear (21 mm)
1 combination gear (8 mm, 31.5 mm)		1 intermittent gear
IMPORTANT
	TWhen assembling the right frame assembly,
	attach the 11 parts listed in step 8 to the right
	frame assembly as shown in the following
	figures.

4-19