Epson TM-FX2180 manual Removing the Front PE Sensor Assembly

EPSON FX-2180 Service Manual	Chapter 4 Disassembly and Assembly
4.2.11.11 Removing the Front PE Sensor Assembly	4.2.11.12 Removing the Main Board Assembly

1.Remove the printer cover, front and rear edge guide assemblies, front cover, paper eject assembly, and front and rear tractor units. (See section 4.2.1.)

2.Remove the panel board assembly. (See section 4.2.2.)

3.Remove the upper housing assembly. (See section 4.2.7.)

4.Remove the printer mechanism. (See section 4.2.11.)

5.Turn the printer over, and insert a standard screwdriver or other prying tool into the hole in the rear frame.

1.Remove the printer cover, front and rear edge guide assemblies, front cover, paper eject assembly, and front and rear tractor units. (See section 4.2.1.)

2.Remove the panel board assembly. (See section 4.2.2.)

3.Remove the upper housing assembly. (See section 4.2.7.)

4.Disconnect the cables from the following connectors on the main board assembly.

Table 4-7. Main Board Connectors

6.	Release the two clips while pushing up the front PE sensor with the	Connector	Pins	Connector	Connector	Pins	Connector
	screwdriver or other prying tool. See Figure 4-38.
		Number		Color	Number		Color

7.Disconnect the front PE sensor connector and then remove the front PE sensor assembly.

c l i p s

CN3	10	white	CN4	3	white
CN5	3	black	CN6	2	white
CN7	4	gray	CN8	18	gray
CN9	16	gray	CN10	4	white
CN11	5	white	CN12	4	white
CN13	4	black	CN15	22	white

Note:

To disconnect the cables from CN10 and CN11, pull up the connector

Ylocks.

To disconnect the cable from CN3, push down on the connector cover.

r e a r f r a m e
f r o n t	P E s e n s o r a s s e m b ly

Figure 4-38. Removing the Front PE Sensor Assembly

4-26