Epson TM-FX2180 Performing the Bi-d Adjustment Using the Settings Diskette, Destination Setting

EPSON FX-2180 Service Manual

5.2.2.1Performing the Bi-d Adjustment Using the Settings Diskette

1.Make sure the PC is turned off. Insert the Settings diskette into drive A of the PC and turn on the PC.

2.Exit Windows and go to the DOS prompt.

3.At the DOS prompt, type GWBASIC J10a72v.bas and press Enter. You see the Printer Select menu.

Program : J******	Setting : *****
9 pins VR 0 = 0	VR 1 = 0	VR 2 = 0

[ Printer select ]

>(1) 9 pins

(2) 24 pins

Figure 5-5. Printer Select Menu

4.Use the − or ↓ key to highlight 9 pins and then press Enter. You see the Setting File menu.

Program : J******		Setting : ******
9 pins	VR 0 = 0	VR 1 = 0	VR 2 = 0
[	Setting File	]

>(1) DEFSTD

(2)EURSTD

(3)NLSP

(4)ITALIC

(5)RUSSIAN

Figure 5-6. Setting File Menu

5.Use the − or ↓ key to highlight the factory setting for the printer’s destination and press Enter. Refer to Table 5-3 for destination settings.

		Chapter 5 Adjustments
	Table 5-3. Destination Settings
Destination	Setting	Destination	Setting
EAI	USASTD	EAI (Latin)	USASTD
EIRO	EURSTD	EDG	EURSTD
EUL	EURSTD	EUL	EURSTD
		(SCANDINAVIA)
EFS	EURSTD	EIS	EURSTD
EIB	EURSTD	EDG (NLSP)	NLSP
EUL (MIDDLE	DEFSTD	EAL	DEFSTD
EAST)
ESP	DEFSTD	EHK	DEFSTD

After you select the destination setting, you see the Main menu.

Program : J******		Setting : *****
9 pins VR 0 = 0		VR 1 = 0	VR 2 = 0
[	Main MENU	]
> (1)	Bi-d Adjust	(6) Envelope
(2)	FF paper	(7) ---- N/A ----
(3)	A3 Cut sheet	(8) -- SUB MENU

(4)A4 1P Cut sheet

(5)A4 6P Cut sheet

Figure 5-7. Main Menu

6.Use the − or ↓ key to highlight Bi-d Adjust and press Enter.

5-5