Epson TM-FX2180 manual Removing the PF Motor Assembly

EPSON FX-2180 Service Manual

4.2.11.2 Removing the PF Motor Assembly

1.Remove the printer cover, front and rear edge guide assemblies, front cover, paper eject assembly, and front and rear tractor units. (See section 4.2.1.)

2.Remove the panel board assembly. (See section 4.2.2.)

3.Remove the upper housing assembly. (See section 4.2.7.)

4.Remove the printer mechanism. (See section 4.2.11.)

5.Move the paper release lever to the pull tractor position.

6.Remove the CBS screw (3 × 6) and the CB screw (3 × 8) securing the PF motor to the right sub frame.

7.Remove the PF motor from the right sub frame.

Chapter 4 Disassembly and Assembly

p a p e r r e le a s e le v e r

P F m o t o r

C B s c r e

IMPORTANT

Before attaching the PF motor to the right sub frame, set the paper release lever to the pull tractor position (full release position).

The CB screw (3 × 8) is used to secure the upper part of the PF motor. The CBS screw

(3 × 6) is used to secure the lower part of the PF

Tmotor.

The tightening torque for the CB and CBS screws is 0.8 - 1.0 Nm (8 - 10 Kgf-cm).

C B S s c r

r ig h t s u b f r a m e

Figure 4-22. Removing the PF Motor

4-16