EPSON
You see the
<
>Mode 0 = 0 Mode 1 = 0 Mode 2 = 0
9IMPORTANT
Chapter 5 Adjustments
The adjustment values are stored in the EEPROM only when you turn off the printer. Turn the printer off and then on again after you perform the
Cancel | Speed |
|
| Value | Write | Default | ||||||||
[ ESC ] | [ SPACE ] | [ |
|
|
| ] | [ |
|
|
|
| ] | [ RET ] | [ HOME ] |
Figure 5-8. Bi-d Adjustment Menu
7.Use the − or ↓ key to highlight the mode. Then press the space bar to print the current
Mode 0 | VR0 = 0 |
HHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHH HHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHH HHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHH HHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHH
Figure 5-9. Current Bi-d Print Alignment Pattern
8.If the
shifted to the right of the first row, change the value by pressing the ← key. If the second row is shifted to the left of the first row, change the value by pressing the → key. Press the space bar to print the new
9.Perform steps 7 and 8 for each mode (0,1, and 2).
10.After you correct the bidirectional print alignment for each print mode, press Enter to print the adjustment values. The program returns to the Main menu.
11.To exit the program, press Esc until you return to the DOS prompt.
5.2.2.2Performing the Bi-d Adjustment from the Control Panel
1.Make sure that continuous paper is loaded and the printer is turned off.
2.Turn on the printer while holding down the Pause button to enter bidirectional print alignment adjustment mode. The printer prints an instruction sheet that contains 25 Super Draft mode alignment patterns.
Figure 5-10. Super Draft Alignment Patterns
3.Look for the pattern with the best alignment on the sheet.