Toshiba B-SX600 manual Media and Ribbon, Supply Specifications, Strip mode Cut mode

3. MEDIA AND RIBBON

3.1 Supply Specifications

Item		Batch/Tear-off mode	Strip mode	Cut mode
Media width (Backing			15 mm to 120 mm
paper width)
Media thickness (total)			0.08 mm to 0.26 mm
Media pitch		5 mm to 1,000 mm	12 mm to 1,000 mm	10 mm to 1,000 mm
Label length	-		10 mm to 998 mm ∗1	-
Label width	-		10 mm or more	-
Label thickness	-		0.05 mm or more	-
Backing paper	-		0.1 mm or less	-
thickness
Material of backing	-		Glassine paper	-
paper
Media type (Roll		Roll (Inside/outside)	Roll (Inside)	Roll (Inside/outside)
direction)		Fanfold ∗2		Fanfold
Max. outside roll		∅200 mm
diameter
Inner core diameter		∅76.2 mm
Ribbon width		30 to 120 mm (A ribbon must be at least 10 mm wider than the loaded
		media.)
Ribbon roll direction		Ink side faces outside
Ribbon inner core		∅25.4 mm to ∅ 26.4 mm
diameter
End of ribbon		Minimum of 200 mm long silver film is attached to the end of the ribbon.
Outside roll diameter		∅70 mm or less (Ribbon length: Approx. 300 m or less)

∗1 If the length of a label is long, place the printer on a surface where an ejected label does not stick to the printer or floor.

∗2 Feed fanfold paper from back of the printer. (→ 5.3 How to Load Fanfold Paper)

∗3 Use a ribbon that is at least 10 mm wider than the media.

Supplemental Remarks

･In the case of peel-off operation, use of perforated labels is not allowed.

･Feed fanfold paper through the Fanfold Paper Slot on the printer back.

3- 1