Toshiba B-9700-LAN-QM-R, B-SX5T, B9700LANQMR manual Label

2. SUPPLY SPECIFICATIONS

EO10-33013B

2.1 MEDIA

NOTES:

1.To ensure print quality and print head life use only TOSHIBA TEC specified media.

2.The media length specifications for use of the cutter are:

*1: When issuing a label using the swing cutter, label length should be 35.0 mm – (Gap length/2).

*2: The rotary cutter does not support the print speed of 10”/sec.

3.When marking black marks on the label rolls, they should be marked at the gaps.

4.“On the fly issue” means that the printer can feed and print without stopping between labels.

5.There are restrictions in use of the media which is narrower than 50 mm. For details, refer to TOSHIBA TEC Head Quarters.

6.When perforating the media, it should be done from the print side to the reverse side.

7.The reflectance of the black mark should be 10% or less when the wavelength is 950nm.

8.The label length should be at least three times as long as the gap.

9.When taking up the printed media onto the take-up spool in batch mode, the outer roll diameter must not exceed 180mm.

10.When cutting the thermal label, secure a gap of 6 mm or more, and cut in the middle of the gap.

11.For the backing paper Glassine paper 7K white or equivalent should be used. Also, the light transmission rate of the backing paper should be 22% or above.

12.Ink used for pre-printing the media should not contain hard substances such as carbonic calcium (CaCO3) and Kaolin (Al2O3, 2SiO2, 2H2O).

13.Thermal paper used for the direct thermal printing must not have the specifications which exceed Ca2+, K +, Na+ 800 ppm, K + 250 ppm, and Cl – 500 ppm.

14.Avoid using media containing SiO2 or talc which wears the print head protection layer.

1) Label

	< Design >
2.0~20.0 mm
		76.2 mm	Max.
			200.0 mm
Backing	10.0 ~ 1500.0mm		(Reference Value)
Paper

Label

1.5 mm 1.5 mm

27.0– 109.0 mm (27.0 - 137.0 mm)

30.0– 112.0 mm

(30.0 – 140.0 mm)	Backing Paper	Label
( ): SX5T

2) Tag paper	Black mark or Square holes
	(Round holes are not acceptable.)
	Black Mark
	76.2 mm
	2.0 ~ 10.0 mm
Min.12 mm	10.0 ~ 1500.0 mm

		Print Side
	30.0 ~ 112.0 mm	Label
30 0 ~ 112 0 mm
(3

( ): SX5T

Max.200.0

NOTE: The reflection rate of the black mark is 10% or less at wavelength of 950nm. A square hole can substitute for the black mark. When the square hole is used, no printing is allowed on the black side.

2- 2