Toshiba TOSVERT VF-FS1 Series instruction manual NvoStatus Object Status

E6581373

5.2.3. nvoStatus (Object Status)

Output network variable, Node Object 0000_20 (Mandatory) SNVT type: SNVT_obj_status (93)

This is the variable to inform the object status. LONWORKS option unit supports some status shown in the table below.

Bit	Request	Description
---	object_id	object_id of requested functional block
0	invalid_id	Set to “1” if a request is received for a functional block index that is not
		defined in the device. No further checking of the request code is
		required when set to one.
1	invalid_request	Set to “1” if an unsupported request code (RQ_xxx) is received on the
		“nviRequest” input network variable.
2	disabled	Under the disabled state,
		-	Output network variables belonging to the functional block are not
			propagated to the network. However, it must be possible to poll
			the output network variables of a functional block in this state.
		-	The functional block must not respond to any updates received on
			its input network variables, but it must support reading and writing
			of any configuration properties belonging to the functional block.
		-	If the functional block was already in the disabled state, a request
			to disable the functional block is not an error.
		-	If the Node Object functional block is disabled, any other requests
			for the Node Object functional block are not disabled.
		- Status and alarm reporting via the “nvoStatus” outputs is not
			disabled when the Node Object functional block is disabled.
17	in_alarm	Set to “1” if the inverter fault occurred or Communication fault
		between the LONWORKS option unit and the inverter occurred.
19	report_mask	Set to “1” if an RQ_REPORT_MASK request is received by the
		“nviRequest” input network variable.

- 15 -