Toshiba B-852-TS12-QP owner manual Connecting the Power Cord

Page 16

2. PRINTER SETUP

ENGLISH VERSION EO1-33028

2.5 Connecting the Power Cord

2.5Connecting the Power Cord

CAUTION!

1.Make sure that the printer power switch is

turned to the off position before connecting the power cord to prevent possible electric shock or damage to the printer.

2.Use only the power cord supplied with the printer. Use of any other cord may cause electric shock or fire.

3.Connect the power cord to a three-prong outlet only, with the third prong being a good ground (earth) connection.

1.Make sure that the printer power switch is in the off position.

Power Switch

2.Connect the Power Cord to the printer as shown in the figure below.

Power Connector

3.Plug the other end of the Power Cord into a grounded outlet as shown in the figure below.

Power Cord

E2- 5

Image 16

Contents 852-TS12-QP List of Standard of Conformity 852-TS12-QP 6DIHW\6XPPDU\ Precautions Request Regarding MaintenanceTable of Contents E6-1 EA1-1EA2-1 EA3-1Product Overview Introduction FeaturesUnpacking Accessories Dimensions AppearanceFront View Rear ViewOperation Panel InteriorPrinter Setup PrecautionsProcedure before Operation Assembling the Accessories Assembling the Supply Holder FrameConnecting the Cables to Your Printer Connecting the Power Cord Turning on the Printer Turning the PrinterTurning OFF the Printer Installing the Media onto the Supply Holder Unit Loading the MediaSpacer Supply Holder Printer Loading Media into the Printer Head Pressure Adjust Lever Setting the Feed Gap Sensor Setting the Black Mark SensorLoading the Ribbon Disconnect the mainsInserting the Optional Pcmcia Cards COMTest Print If necessary, the print test may now be repeated from step E2-17 Overview Printer OperationOperating Modes Operating Modes On Line Mode Operation PanelOperation Reset Dump Mode Restart keyPrint Conditions Cleaning MaintenancePrint Head/Platen/ Sensors Covers and Panels Optional Cutter ModuleTroubleshooting Error MessagesPossible Problems Possible Problems Causes SolutionsRemoving Jammed Media Threshold Setting Feed keyAppendix 1 Specifications A1.1 PrinterA1.2 Options A1.3 MediaA1.3.1 Media Type LabelA1.3.2 Detection Area of the Transmissive Sensor A1.3.3 Detection Area of the Reflective Sensor A1.3.4 Effective Print AreaA1.4 Ribbon Symbols in the message Appendix 2 Messages and LedsFollowing message appears Appendix 3 Interface „Interface CablesAppendix 4 Print Samples Appendix 4 Print Samples UPC-A Glossaries Bar codePre-printed media Index Index