Toshiba B-852-TS12-QP Turning the Printer, Turning on the Printer, Turning OFF the Printer

Page 17

2. PRINTER SETUP

ENGLISH VERSION EO1-33028

2.6 Turning the Printer ON/OFF

2.6Turning the Printer

ON/OFF

2.6.1 Turning ON the Printer

CAUTION!

Use the power switch to turn the printer On/Off. Plugging or unplugging the power cord to turn the printer On/Off may cause fire, an electric shock, or damage to the printer.

When the printer is connected to your host computer it is good practice to turn the printer ON before turning on your host computer and turn OFF your host computer before turning off the printer.

1.To turn ON the printer power, press the power switch as shown in the diagram below. Note that ( ) is the power ON side of the switch.

Power Switch

NOTE:

If an error message appears in the display instead of the ON LINE message or the ERROR LED lamp is illuminated, go to Chapter 6.1, Error Messages.

2.Check that the ON LINE message appears in the LCD Message Display and that the ON LINE and POWER LED lights are illuminated.

2.6.2 Turning OFF the Printer

CAUTION!

Do not turn off the printer power while the media is being printed as this may cause a paper jam or damage to the printer.

Do not turn off the printer power while the ON LINE light is blinking as this may cause damage to your computer.

1.Before turning off the printer power switch verify that the ON LINE message appears in the LCD Message Display and that the ON LINE LED light is on and is not flashing.

2.To turn OFF the printer power press the power switch as shown in the diagram below. Note that ({) is the power OFF side of the switch.

Power Switch

E2- 6

Image 17
Contents 852-TS12-QP List of Standard of Conformity 852-TS12-QP 6DIHW\6XPPDU\ Request Regarding Maintenance PrecautionsTable of Contents EA1-1 E6-1EA2-1 EA3-1Unpacking Introduction FeaturesProduct Overview Accessories Appearance DimensionsFront View Rear ViewInterior Operation PanelPrecautions Printer SetupProcedure before Operation Assembling the Supply Holder Frame Assembling the AccessoriesConnecting the Cables to Your Printer Connecting the Power Cord Turning OFF the Printer Turning the PrinterTurning on the Printer Loading the Media Installing the Media onto the Supply Holder UnitSpacer Supply Holder Printer Loading Media into the Printer Head Pressure Adjust Lever Setting the Black Mark Sensor Setting the Feed Gap SensorDisconnect the mains Loading the RibbonCOM Inserting the Optional Pcmcia CardsTest Print If necessary, the print test may now be repeated from step E2-17 Operating Modes Printer OperationOverview Operating Modes Operation Panel On Line ModeOperation Reset Restart key Dump ModePrint Conditions Print Head/Platen/ Sensors MaintenanceCleaning Optional Cutter Module Covers and PanelsError Messages TroubleshootingPossible Problems Causes Solutions Possible ProblemsRemoving Jammed Media Feed key Threshold SettingA1.1 Printer Appendix 1 SpecificationsA1.3 Media A1.2 OptionsA1.3.1 Media Type LabelA1.3.2 Detection Area of the Transmissive Sensor A1.3.4 Effective Print Area A1.3.3 Detection Area of the Reflective SensorA1.4 Ribbon Appendix 2 Messages and Leds Symbols in the messageFollowing message appears „Interface Cables Appendix 3 InterfaceAppendix 4 Print Samples Appendix 4 Print Samples UPC-A Bar code GlossariesPre-printed media Index Index