Toshiba B-852-TS12-QP owner manual List of Standard of Conformity

Page 2

LIST OF STANDARD OF CONFORMITY

Manufacturer	:	TOSHIBA TEC Corporation
Address	: 570 Ohito, Ohito-cho, Tagata-Gun, Shizuoka-Ken, 410-2323
		Japan
		declares that following product
Product Name	:	Bar Code Printer
Model	: B-852-TS12-QP
Options	:	All
		conforms to the following product specifications
Generic Standard	:	EN 50 082-1
Safety	:	EN 60 950
EMC	:	EN 55 022
Harmonics	:	EN 61000-3-2, 3

Supplementary Information

The product herewith complies with the requirements of the Low Voltage Directive 73/23/EEC, and the EMC Directive 89/336/EEC.

The product was tested in a typical set up TOSHIBA TEC personnel advocated.

VORSICHT:

∙Schallemission: unter 70dB (A) nach DIN 45635 (oder ISO 7779)

∙Die für das Gerät Vorgesehene Steckdose muß in der Nähe des Gerätes und leicht zugänglich sein.

HP-PCL5 is a registered trademark of Hewlett Packard Corporation.

Centronics is a registered trademark of Centronics Data Computer Corp.

Microsoft is a registered trademark of Microsoft Corporation.

Windows is a trademark of Microsoft Corporation.

Copyright © 2000

by TOSHIBA TEC CORPORATION All Rights Reserved

570 Ohito, Ohito-cho, Tagata-gun, Shizuoka-ken, JAPAN

Image 2

Contents 852-TS12-QP List of Standard of Conformity 852-TS12-QP 6DIHW\6XPPDU\ Precautions Request Regarding MaintenanceTable of Contents EA2-1 E6-1EA1-1 EA3-1Unpacking Introduction FeaturesProduct Overview Accessories Front View DimensionsAppearance Rear ViewOperation Panel InteriorPrinter Setup PrecautionsProcedure before Operation Assembling the Accessories Assembling the Supply Holder FrameConnecting the Cables to Your Printer Connecting the Power Cord Turning OFF the Printer Turning the PrinterTurning on the Printer Installing the Media onto the Supply Holder Unit Loading the MediaSpacer Supply Holder Printer Loading Media into the Printer Head Pressure Adjust Lever Setting the Feed Gap Sensor Setting the Black Mark SensorLoading the Ribbon Disconnect the mainsInserting the Optional Pcmcia Cards COMTest Print If necessary, the print test may now be repeated from step E2-17 Operating Modes Printer OperationOverview Operating Modes On Line Mode Operation PanelOperation Reset Dump Mode Restart keyPrint Conditions Print Head/Platen/ Sensors MaintenanceCleaning Covers and Panels Optional Cutter ModuleTroubleshooting Error MessagesPossible Problems Possible Problems Causes SolutionsRemoving Jammed Media Threshold Setting Feed keyAppendix 1 Specifications A1.1 PrinterA1.3.1 Media Type A1.2 OptionsA1.3 Media LabelA1.3.2 Detection Area of the Transmissive Sensor A1.3.3 Detection Area of the Reflective Sensor A1.3.4 Effective Print AreaA1.4 Ribbon Symbols in the message Appendix 2 Messages and LedsFollowing message appears Appendix 3 Interface „Interface CablesAppendix 4 Print Samples Appendix 4 Print Samples UPC-A Glossaries Bar codePre-printed media Index Index