Toshiba B-852-TS12-QP Loading the Media, Installing the Media onto the Supply Holder Unit

2. PRINTER SETUP

ENGLISH VERSION EO1-33028

2.7 Loading the Media

2.7 Loading the Media	The following procedure will outline the steps required to install the
	media onto the Supply Holder Unit and adjust its position in the Supply
	Holder Frame at the rear of the B-852 printer. The procedure will then
	show the steps to properly load the media into the printer so that it feeds
	straight and true through the printer.

2.7.1Installing the Media onto the Supply Holder Unit

The figure below shows the assembled Supply Holder Unit and the paragraphs that follow show the step-by-step procedures to disassemble the Supply Holder Unit, install the media onto the Supply Shaft, then reassembling the Supply Holder Unit so that the auto centering mechanism will automatically center the media on the Supply Shaft.

Removable

Supply Holder

Narrow Slot

2

1	Wide Slot
Green Supply Holder
Locking Knob	Supply Shaft

Stopper

3

Non-removable

Supply Holder

NOTES:

1.The Non-removable Supply Holder is the one that slides in the wide slot while the Removable Supply Holder is the one that slides in the narrow slot.

2.Do not turn the Supply Holder Locking Knob anti-clockwise too far, or it may come off the Supply Holder.

Disassembling the Supply Holder Unit

1.Position the Supply Holder Unit as shown in the above diagram so that the Non-removable Supply Holder is at the right.

2.Rotate the Green Supply Holder Locking Knob in the direction of arrow c (counterclockwise) to loosen the Removable Supply Holder.

3. Slide the Removable Supply Holder in the direction of arrow d to remove it from the Supply Shaft.

4. Rotate the green Supply Holder Locking Knob in the direction of arrow e (counterclockwise) to loosen the Non-removable Supply Holder.

5.Slide the Non-removable Supply Holder all the way to the end of the Supply Shaft until it stops.

E2- 7