Toshiba B-852-TS12-QP owner manual A1.2 Options, A1.3 Media, A1.3.1 Media Type, Label, Tag paper

APPENDIX 1 SPECIFICATIONS

ENGLISH VERSION EO1-33028

A1.2 Options

A1.2 Options

Option Name	Type	Description	Source
Cutter module	B-7208-QM	A stop and cut swing cutter.	See NOTE.
PCL5 interface board	B-7708-PCL-QM	These boards enable the B-852 printer to support the	See NOTE.
		HP-PCL5.
Expansion I/O	B-8700-IO-QM	Installing this board in the printer allows a	See NOTE.
interface board		connection with an external device with the
		exclusive interface, such as the keyboard module.
Keyboard module	KB-80-QM	This module is an external intelligent keyboard unit,	See NOTE.
		including a 16 digit by 2 line LCD and 28 key
		switches.
PCMCIA interface	B-7708-PC-QM	This board enables the use of the following	See NOTE.
board		PCMCIA cards.
		LAN card: 3 COM EtherLink® III (recommended)
		ATA card: Conforming to PC card ATA standard
		Flash memory card: 4MB card (See page 2-14.)
NOTE:

Available from your nearest TOSHIBA TEC representative or TOSHIBA TEC Head Quarters.

A1.3 Media

Please make sure that the media that will be used is approved by TOSHIBA TEC. The warranty does not apply when a problem is caused by using media that is not approved by TOSHIBA TEC.

For information regarding TOSHIBA TEC approved media, please contact a TOSHIBA TEC authorised service representative.

A1.3.1 Media Type

Two types of media can be loaded for this thermal transfer and direct thermal printer label or tag. The table below shows size and shape of the media available for this printer.

			Black Mark				Black Mark
		Label	(on reverse side) Refer to
			NOTE 3 below.			Tag paper	(on reverse side)
Stop				Stop
position	i
				position	i
Cut position

f	g
j	Cut position

c

c

d

h	h
e	e
	Feed Direction

EA1- 2